I changed out the wiring on my 71 demon 340 with M&H factory style harness from YR1.
I recently got the factory 71 idle solenoid rebuilt/refurbished and want to install but I do not see a wiring harness for it or wire from the main harness?
The FSM shows a dark blue wire going to the ballast if...
****ALL SOLD****
Slightly used - Power Master #3257 starter - used only to get the car running after engine rebuild then found date coded starter - NEW $248, will sell for $100
NEW - Tuff Stuff alternator 130 AMP - I had painted the pulley to match OEM, then found correct date coded alt. -...
NEW - Header bolts hex head (9) - $10
NEW - 1970-71 340-440 Carter AVS Idle solenoid bracket - $30
NEW - A/B hood scoop mounting nuts x 11 - $15 ***SOLD***
USED - freshly refurbished A body blower motor mounting bracket to firewall with new gasket - $30
****PM IF YOU NEED TO SEE CLOSE UP...
NEW - Pack of (3) different Master cylinder gaskets ; 2) foam 1) gasket material - $6 made by Detroit Muscle Tech.
NEW - 69-74 brake distribution block part #BLK250 - $60
NEW - (rebuilt) by Brake/Equipment Warehouse in MN - Weatherhead brake distribution valve - $200
NEW - 72-76 A body Rear...
Mr. Norms - Dream Motors Super Charger vintage sticker - $40 - Will sell unframed for $25
Dodge Scat Pack banner - $25 ***SOLD***
NEW - A BODY Fresh air vent to cowl seal (DMT) 63-66 fresh air vent to cowl, 67-76 NON A/C heater box to cowl, 67-72 AC heater box to cowl $8
NEW - (1) Rallye...
NOS - 340 McCord Mc4522 LH exhaust gasket.
Left end flange separated from the rear (see pics) Easy repair and once installed should not move.
$500 + the ride
Very hard to find these days as the Mopar Performance repop was discontinued two years ago.
PM here on the board-
Located in NW Indiana
Looking for power disc brake master cylinder - Mopar part number 2944453 and will have casting number #2229171 on the bottom.
Similar to attached photos -
PM here on the board please -
****SOLVED****
First; THANK YOU to everyone that took time to help diagnose this issue. Been away for a few days for baseball and wanted to report back.
While working with these horns, accidently dropped one on the garage floor and when I picked it up, there was a chunk of crud on the floor...