Recent content by rm21h8a

If anyone one needs any Chrysler diagrams I have access to dcc tools Chrysler diagrams.

Has anyone used a factory harness from an 09 up engine. I have wired in the asd, fuel pump and starter relays. I have grounded pin 21 for the clutch switch. I am using a pcm from modern muscle supposed to have can c start removed. Anyone have an idea of what I am missing. I have no low side...

truck ones will fit with a little modification of the downpipe flanges.

If i change the crank reluctor to the 08 down reluctor and lock out the cam phaser can i run an 05 truck pcm. Are the cam signals the same on vvt cam reluctor?

There has definately been some trial and error going on here lol. If i had to do it over i would have used an older engine. I talked to someone at either modern or bouchillion awhile back and all they would tell me for the eagle stuff is its how it is wired and your only option is an 09 pcm...

The only thing pcm looks for on can c bus is the tipm inputs to start. I tried a while back to use witech but it wont see the pcm unless tipm is there. I have 12v constant to pin 10 and 29. pin 11 run/start I have from the factory switch (The factory electronic ignition cars have a start...

Im not using the tipm i wired asd relay starter relay and fuel pump relay external like we are doing the r09 recalls. Im just not sure what pcm is looking for it say its ok to start. Ive been beating my head against a wall and staring at diagrams for hours

They set the engine too far back. And too far down in my opinion. And i feel like the have too much movement to them

I am using their mounts on a 74 duster using a 68 v8 frame. I am not very impressed with how they fit. I have used their 426 hemi conversion mounts and they worked and fit great, but not very impressed with their 5.7 mounts.

I have played with this harness and tried everything I can think of. I have no low side drivers on the coils or the injectors. I also have no low side driver to actuate the starter relay. I have all asd outputs to injectors and coils. The engine is a 2012 but I am using a 2009 dr (truck) pcm and...

Did anyone get the start function figured out on 2009 up pcm. Im a chrysler tech have all the diagrams. I have both asd br/wt i have initial 1.8 second power up of coils but no low side driver on coils or injectors. I can manually crank the engine by jumping the relay but i have no low side...