Recent content by Rob Eppler

9.50's @ 138-138 Small block R-3/Brodix heads-Roller cam. 904/Dana 60:4.56. 5.97-6.00 in the 1/8.

A little more detailed shots.

67-383 S now 440 w/indy heads and intake. 727/Dana 60 4.10 Full exhaust and Drag Radial "R" tires. Consistent 10.70's @ 125. "Nice street behavior too!"

Work in progress

I just ordered parts from Speedway Motors 3/4" X 36 spline universal joint a 24" section of 3/4" solid round stock and a coupler 3/4-3/4. I doing away with the factory steering coupler at the gear box just in case of exhaust clearance issues. This is my way around buying a used steering column...

This pix was the sand blaster doing the work. I was the smarter guy taking the pix! This is its older brother! A 1/4 mile car. The 66 Dart GT I want to be an EFI car street driver

Pretty sure that 727 didn't fit real easy??? Trying my hand at doing a 66 Dart. Lots of work but I'm ok with that.

Agree, I've had mine off a couple times for paint. Most all the trim has bolts and pal nuts only a couple push clips on the quarter panel window short trim.

This is my 65, I've owned this car since 1969. It has gone through many different stages of modifications. "Back half, ladder bar, Dana 60, [32X14X15 tires] Wheelie bars, Trans brake; [904], Frame ties, 8 point cage, rack, coil overs front and rear. [no torsion bars] Tube K member and control...

I have a 67 FB, and was ask the question: Are 67-69 door glass all the same? I though so but he said the 69 door glass is different. I know the lock knob is located differently but the glass question I could not answer. Any comments are welcome. Thank you

The car appears to twist some, so Dragstrip use is limited. Once I saw this pix, I stopped using this car for "pleasure like this"

Yes my '67 does have the original K member in. I have purchased a '68 K member in favor of the Idler arm mounting difference. It is now blasted and powder coated. All the simple mods made in respect to original sheet metal! No additional holes. Fuel supply comes from the filler neck hole...

This is my 67. I've owned this since 1978! I have modified this vehicle some. However nothing that can't be un-done by another person. Axle is a Dana, [4.10] Engine is a 440 + .030 [383 is put away] The interior sports Viper bucket seats.[no extra holes in the floor...aluminum adapters to...

I like a smaller wheel.

They are not a specific brand. Home made. And yes they come apart for ease of installation! Because I use B1BA cylinder heads, the spark plugs are relocated! Another reason for the "cut" of the flange. Step tubes: 1 7/8 - 2" -2 1/8 into the merge collectors. I have more info on the...