Recent content by Rt1976

Yes that was my original concern as shown in the photos. I couldn't find a bearing made w/ the correct ID / OD. However looking at it more today, I centered the lobes under the lifter bores and the cam would need to move about 3/8" rearward to allow the bearing to contact the block. I'm...

Anyone install a Milodon 13000 gear dive on a 60mm Cam? I'm currently attempting, and the thrust bearing supplied only contacts the block about 1/8" of an inch. Searched high and low and there doesn't seem to be wider options. So just wondering if its a concern or not. Thanks

8 qt would be good I also plan to have a 3qt accumulator. Not sure about single or dual yet either will probably work. I have a rear sump truck pan on my small block I welded in some baffles and a heater so I can mod it a bit to suit my needs. PM me what you have. Thanks

your inbox is full. please PM details and cost. Shipping zipcode is 46202

no. I plan to install a exterior pickup

Looking for rear sump or dragster style oil pan for RB. Chassis car so center link hole through pan is not needed.

this is it . went to lexan

64-66 Barracuda Rear Glass - $150 Can deliver to Indy Swap meet March 4 & 5 or pick up as I'm only about 15 min away

Good info , Thanks. This will be a four-speed car w/ sintered iron clutch so I should be able to keep it in the sweet spot with a heavier crank and gear ratios. Similarly, I put a lightened flywheel in a Ducati air cooled twin. It would lug if you didn't bring the rev's up when taking off but...

Did you reduce E.T.?

Planning a NA big block drag only engine. I'm cubic inch limited so need to make the most of it. It will be injected on alcohol. Looking at a 4.15 stroke, 480(ish) c.i. Anyone use a SCAT pro series lightweight cranks? Do you like them , is it worth it? How much weight savings is there over a...

Edelbrock 2176 w/ T-stat housing Great shape never ported $225 shipped to lower 48

Milodon 30935 318/340 mains 8qt great shape $175 shipped to lower 48

Quick Time RM-6083 and block save plate - For Jerico/Muncie/G-force to Small Block Mopar $400 plus shipping

Looking for a solid roller. Prefer fastback if a Barracuda. Also prefer Midwest / SE Region. Looking for a super stock drag style project. Need to have (or be able to have) stock rear suspension installed. Fenderwell header cutouts ok but need stock front suspension and steering as well.