Milodon Gear Drive w/ 60MM cam

[Rt1976]

Anyone install a Milodon 13000 gear dive on a 60mm Cam? I'm currently attempting, and the thrust bearing supplied only contacts the block about 1/8" of an inch. Searched high and low and there doesn't seem to be wider options. So just wondering if its a concern or not.

Thanks

 

[Newbomb Turk]

When you have it set up as best you can, how much cam thrust do you have?

I’ve had to machine the hub to get the thrust correct and if I’m following what you are saying that might be your issue.

 

[Garrett Ellison]

I take it that only 1/8 of an inch of inside diameter of the roller shims are contacting the block and you’re looking for a wider thrust washer and Torrington bearing?

 

[Rt1976]

Yes that was my original concern as shown in the photos. I couldn't find a bearing made w/ the correct ID / OD. However looking at it more today, I centered the lobes under the lifter bores and the cam would need to move about 3/8" rearward to allow the bearing to contact the block. I'm thinking the boss maybe was cut back to accommodate this and not need a bearing. Going to make some phone calls tomorrow and find out.