Recent content by RyanSipat

  1. RyanSipat

    Mopar Alley 2021?

    Last time I went, it was at Ohlone in 2010. My car was still in pieces at the time. Was looking really looking forward to this one. Sigh.
  2. RyanSipat

    What Are You Doing To/With Your Car Today?

    Bringin' the band back together. Now I just need the proper head gasket thickness for the ensemble.
  3. RyanSipat

    I’d like to see some rare beaters that are driven.

    Here's my daily driver. I guess you can say it's rare in 2021. Sees north of 5k rpm on a daily basis. Needs work on the secondary squirters.
  4. RyanSipat

    What Are You Doing To/With Your Car Today?

    Installed some tti muffler tips. Didn't realize how much bigger the squares were compared to the factory ones. Tone is a bit sharper now, a little louder at idle, and a lot louder when I'm on the pedal compared to the tti turn downs I had prior.
  5. RyanSipat

    Flowmaster Flowfx sound on 340

    Make sure to post it! Would love to hear it on a 440. Going to sound pretty beasty with the 3 inch probably. Especially with the Tri Ys.
  6. RyanSipat

    Flowmaster Flowfx sound on 340

    I can wait if you can't pick some up this weekend. Just let me know when you got the goods. :)
  7. RyanSipat

    Flowmaster Flowfx sound on 340

    Sounds bad ***! I bet it growls amazing with the pedal down. Did the super turbos cure the drone that you had with the summit turbos? Do you have any wide open throttle videos for the super turbos? Also, where did you buy those muffler tips if you don't mind me asking?
  8. RyanSipat

    Flowmaster Flowfx sound on 340

    I would like to hear all of these on that CD. What's a guy gotta do to hear such greatness? I am in.
  9. RyanSipat

    Flowmaster Flowfx sound on 340

    It came off of my uncle's small block roadrunner in the late 70's early 80's. I think it's 108 LSA. I had a picture of the part number somewhere I believe. Wish I could recall the # from the top of my head, but I installed the cam over a decade ago. Yeah, the 40's were pretty awesome when I had...
  10. RyanSipat

    Flowmaster Flowfx sound on 340

    It has quite the bassy drone at 3k rpm, my phone can't seem to pick up the bass though. Doesn't seem to rattle my falling apart headliner as well as other rattles, but it does sound bassy. For me it's livable (use to it) as my other non-mopar vehicles drone just as bad with magnaflow and borla...
  11. RyanSipat

    Flowmaster Flowfx sound on 340

    Just decided to post the sound of these puppies idling. They have that typical straight through sound, with a sound level of 83db at idle, measured 25 inches away from the tailpipes ( recorded on google pixel 3 XL, sound meter app). They drone at cruise but not as bad as the 40s I had. Those...
  12. RyanSipat

    What Are You Doing To/With Your Car Today?

    Finished MAD wiring, replaced the hurst T-handle with a regular ball, and installed a wideband. Did not know how fat my car ran at idle until installing the wideband. I guess I need to do some adjustments...
  13. RyanSipat

    What Are You Doing To/With Your Car Today?

    Put on a Holley heat shield on my carb. I then swapped out the flex-a-lite fan out for a viscous clutch type my dad had in the garage. I also reset my TDC mark as instructed on this board, and found out the timing mark was actually running 10 initial instead of the 16 i thought I put in with the...
  14. RyanSipat

    What Are You Doing To/With Your Car Today?

    My car has been down for awhile due to the choke. Being the electricity noob that I am, car left me stranded. After a week from recovering from my sad Scooby Doo errors and 16 fouled plugs later (and playing some ELO - Telephone Line), I finally wired a relay correctly for the electric choke. I...
Back
Top