Recent content by ScottieB007

  1. ScottieB007

    Head milling question

    The block decking just was minimum to make sure everything was flat nothing more I guess I'll have them clean up the head surface to what ever makes them true and just tell them to stop at ten thousandths
  2. ScottieB007

    Head milling question

    I have a 1977 318 that's going into a truck , I have got everything as close to blueprint as I can , my question is I'm to the point now of CC'ing my heads one come out at 68 cc the other came out at 67 cc factory spec is 63 cc for those heads , if remove the roughly 5 and 4 cc from each head...
  3. ScottieB007

    [FOR SALE] Miscellaneous Small Block rebuild Parts Cheap

    30 over 318 cast piston rings , standard size main, rod and cam bearings all enginetech brand , which is reboxed King bearings and Hastings rings I called and asked the company personally . 80 dollars plus shipping I'll do a little better on price if someone takes everything I'm in Kentucky
  4. ScottieB007

    Horse power guess

    Is has headers and 1.60 exhaust valves
  5. ScottieB007

    Horse power guess

    1.78 intake , 1.60 exhaust
  6. ScottieB007

    Horse power guess

    That cam was at the suggestion of racer brown
  7. ScottieB007

    Horse power guess

    They are still about 0.060 in the hole hopefully once we are completely done it will be at 9 - 5 to 1 which is where I want to stop to run pump gas
  8. ScottieB007

    Horse power guess

    Just stock 77 318 castings milled down
  9. ScottieB007

    Horse power guess

    The only reason that was done was to get the Pistons a little further up in the bore with out buying the 400 dollar piston set not to add cubic inch but it did add a littl
  10. ScottieB007

    Horse power guess

    We opened up the bowls under the valves when we did the 3 angle valve job also opened up the intake ported a little
  11. ScottieB007

    Horse power guess

    I had the crank offset ground to add 20 thousandths stroke , it's been bored 30 thousandths works out to about a 325
  12. ScottieB007

    Horse power guess

    I was guessing 300 to 350
  13. ScottieB007

    Horse power guess

    here's my combo 9-2 to 1 compression , edelbrock performer intake and 650 carb , 61 cc heads ported and 360 exhaust valves stroked to a 325 cubic inch and headers 206 duration cam with .420 .420 intake and exhaust 110 lobe separation, what would you think the horse power and torque should be
  14. ScottieB007

    rocker arms

    Okay that helps quite a bit . I was really struggling on if I needed a new set or not .
  15. ScottieB007

    rocker arms

    What is the main difference between stock 1.5 rocker arms and stock replacement Mopar performance 1.5 rocker arms? Are they better built, closer to 1.5 across the board as opposed to factory stock and finally are they worth the buy? Considering im not going with roller rockers ? I have a 77 318...
Back
Top