Recent content by Sebastian

What clutch do you guys recommend? Am I good with Brewers MC1023 with about 400HP? I will also look into a pilot bearing. Any recommendations there? Dave are you having any issues with the 0.33" disc as well?

The clutch disc is 0.33" thick

Update: So I took out the clutch and it was installed the right way but of course the springs got hit. The pilot bearing sits really lose. I can push it in and pull it out no problem. Is it supposed to be a tight fit?! How do I know if my flywheel is ok? I will go out and measure the thickness...

Sorry guys I haven't even been home the last couple of days. As soon as I have the time to take the rest apart I'll let you know!

Thanks for all the help guys! Yes that pilot bushing is just lose in there.... At least I'm finding stuff that explains my issue and I'm glad I opened it up. I didn't get a chance yet to pull the clutch but hopefully tomorrow I can give an update!

I'll get a new clutch and replace everything. Not what I was hoping for but oh well

The throw out bearing seems alright. It's not as smooth as others bearings I had in my hand but then idk if that is necessary?

So I just took a closer look at the clutch and it's a PHT??? Never heard of that company. What is concerning me is one of the springs sticks out?! That can't be good

Just a thought right now the Z bar might be bend because there's pretty much no space between the starter and the headers? Anybody have the same issue?

How do I even know if it's the right Z Bar? Thank you guys for all the help!!

Z Bar

So I took the transmission out and the Z bar. Didn't get to the bell housing yet. What I found that the Z bar looks bend/warped. Should be straight correct? Also the one plastic bearing looks f..... As well. Could that be the whole problem? At that point I might as well take the clutch out too.

I took over this project from somebody else. Motor, Clutch and Tranny are new. I assume it never worked right. It doesn't matter how I adjust the clutch the issue is always the same. I push the pedal and the clutch disengages, I am able to put it in gear and wheels spin. Then if I push the pedal...

I have the exact same issue. Did you get it resolved?

Ok so I spend the day troubleshooting and the issue is the following: I'm not able to put the car in any gear while the engine is running. When engine is off all gears go in fine. Now I noticed when I push the clutch I can hear and feel touching at about 3/4 way in and it goes away if I keep...