Recent content by sgaugian

Check these out. Mancini Racing Steel Rocker Arm Set, 1.5 Ratio Item #: MRE49742-S Write a Review Price: $121.99 Quantity:

Do you still have the W11 deluxe wheel covers?

High School Rod

Woodruff Carburetor Does Excellent Work. Dave, Thanks for your work done to my AVS 4933S carburetor. Your restoration work is top notch, and your setup was right on because my car started right up. Below is a picture of before and then all the after photos. Brian

Gunthers Machining & Rebuilding 301-898-5840 10409 B Woodsboro Pike Walkersville, MD 21793 They are good people and did an excellent job on my 340 a couple of years ago.

Also check drilled holes for bolts, I had one of the holes cut into inside indention where oil is and it was leaking from there, even after gasket kit

removed item, not for sale

I purchased this new and used on Brake lines to make up a few lines on my restoration, several years ago. Works great and if you used old style tools, this one is flawless and works every time. $45 and I pay the shipping. PayPal friends and family. Thanks, PM with any questions. Brian

Had the same problems and chased it like you. Finally fixed the problem by inserting 1/2 copper pipe sleeve in adapter where bolt fits into sleeve. If the bolt you have is not tight around the sleeve, problems will continue. Using the gasket kits is correct, but the adapter must be snug around...

I installed mine about 4 years ago and it laid down pretty good, with a little heat from my heat gun on low setting. I also had this rubber flooring originally in 1979 in another 4speed 340 dart and it has bumps about the same as then, with even the new flooring.

Your inbox is full, I will buy the 4933 if you have it, just pm me.

I used a company called Hanlon Plating Richmond, Virginia, maybe a little closer than outwest since you are in fla. 925 E Fourth St. Richmond VA. 23224. Contact Tom Hanlon 804-233-2021. I had both bumpers and exhaust tips done. They were very prompt and the quality was spot on. Pricing was best...

I found a way to solve the leaking 90 degree adapter, 1st clean all the surfaces for the large gasket to seal properly, (use instructions supplied with gasket set) then where the big bolt goes through the adapter put 1/2 copper pipe sleeve (about 1/2" long) in there and use the copper or plastic...

One last piece of advice, I just had to fix the same kind of leak (shaft seal was okay but I replaced it also) and when I pulled it down I found the side walls of one of the bolt holes in the bearing cover broke open causing the fluid to run out the bolt hole and into the same area. In case you...

American Modern through Geico "Maryland" full replacement 25k $240 a year.