I lost my job back in 2012 and had to sell my car and haven’t had one since. Really sad when hot rods are your life! Lol. Sold my big block dart sport to a guy here in Texas and he traded it to a guy in Anniston Alabama. I’ve lost contact with that guy. Anyone knows anything about it that...
My Stealths are 2 yrs old I had them conservatively hand porter, a serdi
Valve jobdone and flow benched. Before the vj the low lift numbers
Weren't very good. ( I don't have the sheet here) but improved
Dramatically after! End result was really good 400 number,290ish at 500
And 304 at 600...
comp cam solid flat tappet for big block 250 255 530 540 108 with matching lifters in order.one bolt cam. broken in perfectly with outers only. i bought it to use in my engine but have decided to go another route. 110.00 shipped conus thanks. Dallas tx
Would trade for power to manual...
guys i HATE to do this but finanaces for sale. weiand tunnel ram for RB chrysler pn 1987 and holley 650 double pumper carbs for sale. the manifold has had the upper to lower opening port matched. (common to have a step in the castings from the factory). and the port exits gently cleaned up and...
pro parts semi fenderwell headers for sale. 2inch primaries. no damage or road rash. these were an older set (2002) and i just had them professionally ceramic coated inside and out. have not been installed since. number 4 tube has been massaged a little for spark plug clearance but other than...
Anyone run the Herman hustler fenderwell headers? I'm thinking
About selling my proparts that I just coated ( beautiful) and
Getting the hedmans. I want better plug access. I think
The tires hitting the tubes is better than hookers..?
I made 325 horse at the tires with a 228 465 110 hyd cam!
370 tq at the tires! WITH THESE heads. Convert those numbers. Factor in a real
Cam! These heads make power.
my buddy larry parks ported the heads. he is a big time pontiac guy in the dallas area. we have a local head porter that bought AFRs old superflow bench so its legit. the stock valves are backcut and the heads are not fully ported. my guy just knows what hes doing. ive sent him a message to...
I am the seller of the heads in question. I don't have a sheet
In my hand but I can get it. These heads have killer 400 lift numbers too
Let me get the sheet. These heads were on a real superflow
Bench BTW