Recent content by sls001

Nice work - in looking at the rear brakes; did you put the brake shoes on backwards? It is hard to tell in the picture but the short shoe should go in the front, the picture looks like you have the short shoe on the rear.

if the bulb holder itself is still ok and it will hold a bulb you should be able to at least flash the codes.

There is no adjustment to the fuel pressure regulator. Check your fuel pressure. These things are very sensitive to fuel pressure issues. In addition, pull the hose off the back of the regulator and see if there is fuel in the line which would indicate the regulator has failed (Note: this...

Any problems with it and does it have main caps? Your not to far off either... Thanks, Shawn

Complete or just a housing? What are you looking to get for it and where are you? Thank you, Shawn

I don't know that much other than what I've read about issues with the early Mega Blocks. Do you know who\when this one was cast? Have any pictures? Thank you,

PM's sent

Thanks for the reply. My goal is to build a high-torque, low RPM stroker for my 4x4 truck which is also my daily driver. I've been seeing stock bored blocks for 250-450 on here, MoParts, etc which is within my price range for a block. While I would probably like your block; the pistons...

Thank you to everyone that replied. Looks like I've found what I needed. I'm going to go check out some that moparfan68 has. Thank you, ---------------------------------------------------------- I am looking for a good 440 block, short block or even a rebuildable 440 in or very close...

1988 up 318's in trucks had roller cams, 89 up on the 360's (started with the TBI system) not certain on the car models