Hi Guys:
Resto Mod Project is out and about, first few hundred miles being put on it waaay south of the border in the Andes Mountains of Ecuador.
Being just under 7K Feet altitude is always a carburetor issue and Edelbrock will only provide Tech Support over the phone....(unreal)
Anyway...
Hey Guys, I finally took my 75 RestoMod for its first Gas Station "Filler Up Please" and discovered before starting the car to leave I had a massive leak from the Filler-Tube/Seal/Tank.
When placing the Seal it appeared to be doing the job correctly (Snug Fit), but now I'm at a loss.
Anyone...
* Outside temperature is between 70-75 deg
* Stalls maybe a min or two after Water temperature reaches max. (Car isn't rolling.. still have other work to perform w/Gearbox so focusing on engine for now)
* Carb is Edelbrock 1404 Performer - Manual Choke.
* Choke not Functioning / Installed at the...
Hey Gents:
I am moving forward but stumbling with my Resto-Mod. Here's my trouble:
Upion a full rebuild and dropping the Engine in my Sport Coupe we did a temporary (testing) Wiring setup so we could run the engine for a few hours, making sure everything was fine (and it was).
BUT: now...
Here are all my pictures and I cannot answer as to the Case Material. But it appears to be aluminum from photos. I'll stop by shop tomorrow if I get a chance.
From what I gather it looks like a '77?
Thanks for your help.