Recent content by sparkie573

Have a list of things that need to be done to it for it to be finished?

Hey all. I have some questions for you guys. I posted in the forced induction spot first but thought maybe I could get some info here as well. I am finally going good on my 70 Roadrunner resto mod and most of exterior bodywork is done and I'm ordering the full cap stiffening kit and spring...

Hey all. I have a few questions for you guys not sure if it needs to go here or in the new hemi spot but I figured I would start here and post it there as well. I am finally going good on my 70 Roadrunner resto mod and most of exterior bodywork is done. I'm going to be using a 5.7 hemi from...

And I'm pretty sure it's a 904. When I got it and changed the filter and pan gasket I took them to the parts store. "A reputable one". And matched up the gasket and filter to a 904 which is what it also stated in his book.. What would be any difference in the other ones? I think I'll unhook the...

Thanks all, I'll start digging into it. Yes, reverse seems to work fine and 1 to 2 shift seems ok also.

I haven't at all. I haven't been driving the jeep to long. You think That would cause my problem? Any insight on that? Thanks.

Hi all. I thought I would try with everyone here before I got to digging into this real deep. I have an 89 YJ wrangler with the 4.2 6 cyl and 904 auto, dana 30,ford rear 8.8 , and 35 inch tires... I am having an issue with the trans that I am having problems diagnosing. it is basically a...

Other one

I have 2 overdrive 4 speeds for sale. I think they are from trucks but can be made to work on anything. They both go in gears and input and output turn. Both look to be in good shape. 1 has everything on it including shifter, shift box, mount, rods and levers... The other one only has the levers...

360 magnum engine sold. Big Block 727 sold. clutch shaft service kit sold clutch rod kit sold. 9" z bar sold.

Pretty set in the EFI...

That was kind of my thinking... If I'd does have skim, I can just get it takes out?? I had planned on having it tuned or using a diablo or something else.

Hey all. I will be doing a 5.7 swap into a 70 roadrunner and have some questions and need opinions or insight.... I am about to buy an engine and have it narrowed down to 2. I can buy an entire wrecked 04 2 wheel drive crew cab Ram for $3500. Or I can get an engine, tranny and wire...

Yes it's still available. 1 hour south of St. Louis

and more stuff yet. rods seem to be kind of a cobbled up set, look to be a body. super shifter box is in unknown condition.