Recent content by Stroked68Dart

If you don’t mind please give me your best guess as to what I should set the timing to: I am getting ready to set the timing on my 402 Mopar crate motor (specs are below). I was given the below timing suggestions as a starting point: 18 degrees at idle 16 degrees at 3200 (34 degrees total) 12...

Please see link at the end of this post to see more photos. All this stuff goes to the highest bidder. Let me know if you are interested. I am cleaning out my garage and attic and have a group of parts from my ’68 and ’69 Darts that I am selling. As you will see from the pictures there are...

Hi guys! I have been searching the forums for an answer to the below question. I did not find an answer but boy I learned a lot about Holley carbs :) My question: I have a Holley 465 cfm carb. When I fully depress the gas pedal it completely actuates the throttle linkage to a complete full...

Got a questions for you guys. I've got a Mopar 402 crate motor in my '68 Dart. You can see the cam and engine specs here: 402 Magnum : CHICAGO CONNECTION, Your High Performance Parts & Accessory Shop The motor has a single plane intake and I'd like to make it more streetable. Given the...

For those that asked, I put an entire new upgraded suspension under my Dart including Wilwood brakes. So, I have axels for a 8 3/4 489, limited slip diff, rear and front suspension, a arms, torsion bars, 4 wheel drum brakes, manual brake cylinder, an assorted selection of Holley 750 vacuum...

Hey Guys! I have a collection of parts from a couple of different projects (68 Dodge Dart build, Rx7 race car build, and Triumph Spitfire race car build) that I am wanting to polish up and maybe sell. Do you know of any swap meets? I am in the East Bay area. Thanks!

Anybody know where I can buy exhaust flanges for a 402 MOPAR crate motor? I looked at Summit and Jegs but didn't find any. Any advice?

Wow guys!! this is EXACTLY the info I needed!! Thank you very much!

Hi KrazyKuda, I am needing to understand what the two wires to the distributer do. Is one just carrying positive current and the other getting the trigger signal from the rotor or ?? thank you for your help O:)

I have 2 quick questions I am hoping you guys can help me with. I have an extra MOPAR ECU box I am wanting to use on a non-Chrysler motor in a race car I inherited. I know... I know... I should get a Chrysler but I don't have the money right now and am having to make due with what I have...

Nope. I am kinda half good with the car and motor. I can do most everything but the distributor or welding is out of my are of expertise and something I would be hesitant to try on my own :-(

I searched through the archived post and couldn't find what I'm looking for so... I live in the San Francisco Bay Area and have a distributor that needs put on a distributor bench and checked out and adjusted for my setup so I can use the vacuum advance and achieve max power with my motor...

I like the look and stance. Do you have any recent photos? Did you go with the 14's? That's what I am thinking of getting.

Could you please tell me the size of your wheels and tires? Great look. Love your Dart.

Thanks for the input guys!...