Recent content by Sublime Swinger

Home Steele Rubber is who I've used for a few projects, everything fits amazng and looks very similar to what I tore off the vehicle.

Engine Paint Codes 70's Blue - 5351D dupont or PPG 2423 Turquoise - 4799D dupont or PPG 13195 (but delete the metal flake) Red - like on 273 high performance - 5092D dupont or PPG 2136 Street Hemi 19665067D dupont or PPG 2186 or PPG 3116 Universal, Chrysler motor Mandarin orange Race Hemi...

Center of the raised longitudinal on both sides and all the way to the pinch weld under the windshield

Accurate exhaust or TTI have some great products.

Close friend has one, used to be a member on here 340swinger4spd. 1970 Y1 top banana 340 4 speed with black buckets and stripe delete.

Sent pm

R/T Specialties - Mopar Fasteners, Clips & Hardware

That makes sense, the longer sleeve helps get the belt in between the bottom and top of the rear seat. And the short plastic sleeve helps keep the belt tight to the side of the bucket. Not sure where your going with this? Is there a difference in belt size or length if the car was originally a...

Build sheet says bench but sometime before I purchased someone added buckets and console floorshift.

Looks like the numbers on the short and long buckles for both sides are American Safety 445588 and the retractor number is 445685 but there is no name on the retractor from what I can see.

Looking for a full front set of black bucket seat seatbelts for my 1970 Dart, mine are too Rusty and pitted to reuse.

Ask around on here, I bet someone probably has what you need laying around. Good luck

Same issue with my 318 in my d200, my pulley was a pre '70 which had an offset hole. I ended up finding a post '70 pulley at a local swap meet and the holes all lined up. Problem solved.