Recent content by TAQuickness

Mac mid length headers may be a good temporary solution.

Anyone have pictures of their factory carpet with the trim removed? In particular, around the door sils. I'm installing new molded carpet and don't know where to trim it (Dart did not have carpet when I bought it). thanks!

This is happening a lot lately. The homeless cannot afford health care insurance.

Pm sent

Pm sent

I wouldn't worry about the quench too much. In theory it promotes a "better" mixture; however, the mixture trapped within the quench area is unable to combust.

I'm looking to re-install my factory AM radio and need to repair this hole in my dash. If you have a photo of an unmolested dash, would you please post it?

On that note, the DMT clips are slightly different than the OEM's. If you need any clips, I saved (most of) mine and you can have them. They have minor surface rust and can be reconditioned with minimal effort. These are original 1965 (Dart) but there are no identifying marks on them that I...

If it helps, Detroit Muscle Technology has a nice (and thorough) heater box and firewall gasket kit.

pm sent

I put black leather buckets from an 01 Dakota in my dart. Driver side is power. Found them on craigs list for 150, no tears, no stains, no blood. I will post pics tomorrow.

Bummer - not the right cap. Thanks for the help/effort though. The cap I'm after fits around the neck and secures itself by the nipples (as seen in the first pic)

Thanks Rally.

Bump.

That's a good controller and meter. Who ever buys it, LC1's require a solid ground source (ie run it back to your battery).