Recent content by TheDuke

My 383 runs like a dream on an Edelbrock AVS2 even when I lean on it. Whomever told you these carbs are trash doesn’t know how to work a carb and just wants to bill you for a 3-5k efi install. Watch a couple videos on YouTube from Muscle Car Solutions of Uncle Tony’s Garage and you will be a...

I don’t know either but it seems to work.

I have the exact same problem you’re having with my tach. I switched coils and had horrible issues with my tach directly after. Everything seemed to read right but I got erratic readings after 2000 rpm. I’m no expert but I did solve the problem. I saw a video auto meter put out about needing to...

short and sweet, I’m looking for those pigtail connectors that attach to a 72 Duster fuel tank and a 383 mopar temp sender. It’s been a pain in the butt to find these. Every similar pigtail (GM) is too small. Could I just put an eyelet on the wire and sandwich it between two nuts on the pole...

You’re so right! Thanks for that. I reviewed the MSD instructions, my wiring kit, my service manual and got a lot of good advice. I’m thinking this is correct! Only difference in the drawing is I’m thinking I’m going to put the maxi fuse on the red battery lug wire instead of coming off the...

Ok, so I did some more research and I believe that I have it now! Does this look right???

I’m trying to piece this together from my old system and MSD’s directions...

Good evening, y’all I’ve been rewiring my 72’ Duster using a KwikWire budget kit for a couple of months now and I’m seeing the light at the end of the tunnel. I saved the ignition portion to last because I knew it was going to be the trickiest. I’m trying to install using MSD’s Ready to Run...

FACTS! Cutting the factory bezel out produces an interesting smell and smoke that I hope I won’t have to pay for later. It takes a brave soul to start hacking up your classic muscle car but in my case, my car is made up of a half dozen other cars and the entire cluster was dead save for the...

Good idea. I’ll look into it.

It’s not wired yet but the leads are there. I’m starting my rewiring project today.

Hello all! I recently decided to redo my dash. I asked a bunch of people if I should repair my factory dash or upgrade to a new more modern style one. After much debate and a near 50/50 split in opinions I decided to do a combination of both ideas. I started with the 1967 series gauge set from...

There are wood textured vinyl decals you can get on amazon for under $20. I recently redid my entire dash

Look up the member Damraider. I got mine from him!