Recent content by Toolman

Not looking to separate at this time.

Yes...clear title with build sheet.

I have a numbers matching (with build sheet & vin tag) 1970 Dart Swinger 340 4-speed project car. it is ROUGH (see pics). I am located in south west Pennsylvania. The car is a roller w/engine and 4-speed removed. Hood, trunk lid, both doors, dash, interior, front and rear glass, bumpers, and...

{Edited by staff: You were asked to come up with an asking price. Best offer is not a price. Take some time and think of a price you want for the whole car. Then feel free to repost your sale ad. }

Nice looking car! Just sent you a PM.

FYI... BackYard Buddy 4-Post lift. Made in Ohio by Americans with American Steel.

Randy, I am so sorry. I have been where you are. A dog can hold a very special place in our hearts. My dog, Blaze ( a yellow lab) is gone, but never forgotten. God Bless.

I have a ridgid that has been very reliable and I recently bought a Milwaukee that I also like a lot. I've tried to buy quality tools (and american made when possible) my whole life and I have yet to regret it. I believe that cheap can be expensive in the long run. Just my old school thoughts...

I have heard good things about SPI...so that's probably what I'll end up with. Also, what are you guys using these days as far as respiratiors go? It's been over 20 years since I did any car painting...I'm sure things have changed. I'm not sure if I'm going to go single stage urethane or...

The reason for epoxy primer is the corrosion resistance factor. I also will be doing a lot of rust repair and the initial blast and prime will cover all the good sheet metal and the rest will be in stages as I replace the rusted metal. The car may be in and out of the garage a few times during...

Looking to get some epoxy primer. I'm going yo use crushed glass to blast the car, then wondering if I need to do anything else before I coat it with epoxy primer? Also there are so many new products with the low VOC stuff, what's the best epoxy primer today that will give good protection and...

Thanks again for the info... I emailed you more pics, hope you get them this time. I know I have a lot of questions and I appreciate you taking the time to do this thread and a ser my questions. I plan on starting a thread once I begin the restoration. Like I said before...you have a gift for...

Pic

Here's a few more pics of the nasty stuff...

May I ask what gun and tip size you use to spray the epoxy primer. I don't think I can get the same Glasurit 801-703 you using...any other recommendations for epoxy primer. Also what did you do to the metal after you blasted it before you primed it? I'm going to start blasting a little with...