I'm selling my Hod Rod to help pay for adoption. I built it a few years ago with my dad and have a ton of great memories, but it's time to sell it. It has about 1000 miles on the build and about 23K in receipts. I'll list what I can remember. 318/904 with 8 1/4. Asking 16K Located in Omaha...
I wish I had my flexplate numbers handy, but I know I had to grind about 1/4 inch off the ends to clear my mini starter. The flexplate had holes for 10 and 11 inch converters. Which is great if you have a 727. I don't think the 904 usually has an 11 inch converter so the universal type flexplate...
New rims and tires this summer following a disk brake and rear end upgrade. Boyd rims 17x7 and American Classic Red Line tires. 235/55/17. They fit great in the back but I had to trim and roll the front fenders.
I've got 2.45's as well.In a rear out of a 75 Duster. Quick question. If I buy this carrier, http://www.ebay.com/itm/DODGE-CHRYSLER-8-25-BARE-OPEN-CARRIER-CASE-27-SPLINE-1996-OLDER-/270903831483?hash=item3f13206bbb&item=270903831483&pt=Motors_Car_Truck_Parts_Accessories&vxp=mtr , can I put on...
Is there an Air Gap Manifold that works with an AC setup? Everything I've read about the Edelbrock ones say that the water neck doesn't clear. Just wondering if there's an option I haven't come across.
Thanks
I'm doing a little part research for rebuilding my 318. It's at the machinist right now getting .040 over and zero decked. It's a 12/72 externally balanced block and I wanted to go to a balanced flex plate and zero balance stall converter in my 904.
I'm just having a hard time finding one for...