Recent content by toypar

  1. T

    [WANTED] 1969 Dart rallye woodgrain steering wheel.

    I know this depends on condition, but does anyone know how much it cost to have an original wheel restored?
  2. T

    [WANTED] 1969 Dart rallye woodgrain steering wheel.

    I don’t really want to pay $800 for a reproduction that isn’t correct. I will let you know if I find one.
  3. T

    [WANTED] 1969 Dart rallye woodgrain steering wheel.

    I heard the repop isn’t correct. I believe the spokes are shiny instead of satin. I will look for the one on eBay.
  4. T

    [WANTED] 1969 Dart rallye woodgrain steering wheel.

    I am looking for a nice condition original rallye wood grain steering wheel for a 1969 dart
  5. T

    [WANTED] Dart disc/drum combination valve

    It is a Kelsey Hayes I need. The valve I currently have is a reproduction and brand new. I cans seem to get it to stop leaking from the bolt on the bottom.
  6. T

    [WANTED] Dart disc/drum combination valve

    Looking for a good original disc/drum combination valve. My new reproduction leaks. So want To try an original. I believe it came on 70-74 dusters and darts.
  7. T

    Thermoquad idling issues

    The dash pot is new and works properly. I will check that adjustment.
  8. T

    Thermoquad idling issues

    An update. I rebuilt a nice untouched 6322s, Phenolic body looked perfect. Installed some 137 secondary jets, 95 primary with 1966 rods. Idling issues have been resolved. Starts with the touch of the key after sitting for an hour and doesn’t run extremely rich at an idle. I also installed a ME...
  9. T

    Thermoquad idling issues

    Scraping at the suspected crack with a pocket knife. Zero epoxy is coming off and it feels like there is a few thousands difference in height between one side or the other of the line. Maybe the rebuild company put epoxy over the crack to try and cover it. This is what I saw last week leaving a...
  10. T

    Thermoquad idling issues

    I did adjust it. But I found fuel dripping into the primary blades and into the intake from somewhere.
  11. T

    Thermoquad idling issues

    It sure felt like a crack. I will clean it up with some scotch brite and see if the epoxy comes off.
  12. T

    Thermoquad idling issues

    I decided to pull my trouble carb apart again while waiting for my rebuild kits. I think I found the problem. A crack by the main well. I filled the bowls up with fuel and can’t get a leak. It must pull fuel through the crack with vacuum when the engine is running. Anybody know where I could...
  13. T

    Thermoquad idling issues

    I will make sure to keep that in mind. Thank you
  14. T

    Thermoquad idling issues

    I will have to give him a call. That’s only a 2 hour drive from my place. It might be worth it for him to restore the rare 71 carb I have.
Back
Top