Recent content by victoriabc67dart

Nice one I'm not a mechanic and don't claim to be one when I need someone to help me with things he's the guy I trust to work on my car , beak all you want it doesn't bother me

hey there i run a holley 750 on my built 360 aswell does my friend and i know two other guys that run them on there 340's and there all setup and tuned by ( Inertia ) he tuned my engine and switch out my edddy 600 for a 750 and the same with my other friends and there was a night and day...

I know it has been a few months since i last posted but the guys who balanced the crank came good for everything i had the motor taken apart and magnafluxed my engine had three damaged pistons and a new oil pump pickup and pan were needed they covered all my fluids and gaskets plus gave me a...

i originally thought because the weld on the slug of metal looked the same as the one on the crank that it was just brazed on there or something until someone on here said that there should be another hole that it actually flung out of so when i pulled the motor last night i looked for the hole...

thanks to everyone for all the input again i pulled the motor and gt it on an engine stand yesterday it was a painful 3 hrs cause i just finished putting it all in and it sucked to have to take it all out but either way the deed is done i told my engine builder that he can deal with the crank...

i talked to the guy who did the crank today and he said he see the motor witch is fair im going to pull it out tonight and put it on an engine stand so it can be inspected he told me if his crank failed he would cover the cost of all the parts and all the fluids and rebuild it all at his shop on...

also does anyone have a photo of a internally balanced crank or a picture of a properly attached weight

just to note the machine shop had the crank sent to a different place to get balanced. the underside of both the rear pistons are for sure damaged and its unknown at this point how much of the shrapnel spread through the motor... where do you see a crack in the block? (which pic)

this is my first post but i have used this website a ton over the last year and a bit while working on my 1967 dodge dart and doing a full swap. I had my motor bored and everything done to it as well as the heads done, during the process i was asked by my machine shop guy if i wanted to have my...