Recent content by Wakeham70

Neutral safety is grounded, but when you said "I took my original starter signal from my ign switch and used it to command the PCM" What pin did you connect the ign wire to? Also what year PCM and engine did you install?

Yes my starter is pcm controlled. I do not recieve any command to my starter relay from the PCM. What did you do if you dont mind sharing? Thank you

No DTC's, ASD is hot on all coils, also the PCM is grounded.

Any idea the best place to get a 2012 PCM flashed. I was told by hotwire that a 2012+ PCM will not work.

Sorry for the poor quality, not sure what happened.

Yes I am recieving Cam and Crank signal, and yes I have full access to tech authority's diagrams. Unfortunatly they seem to be somewhat simplified. See attachment

As far as I know yes they do, as well as the injectors but I have injector pulse, also I have already disabled the SKIM. Which is why I am mindboggeled

Just curious if anyone out there has or is using the hotwire auto hemi swap hotrod wiring harness? If so I have a few questions regarding it.

So a little backround info on my 70 Duster project. I installed a new control freaks front suspension with a 5.7l Hemi out of a 2012 Ram. I used the origional PCM and Harness from the truck as well I used the cars origional 904 Trans. All are bolted up and in place, fitment is good, but here...

Duspan, Would you happen to still have that wiring diagram for the rallye dash. Any help on this would be greatly appreciated. Thanks