broken bearing retainer

-
eds72demon

eds72demon

Well-Known Member
Joined
Jun 29, 2010
Messages
92
Reaction score
0
Location
new jersey
Hey all, went to move my trans yest. and when I grabbed it the front shaft of the bearing retainer broke- see my pic. Are they all the same? I can get a new one for about $70 + shipping, but I'm not sure if they all are the same. Any help is appreciated.
 

Attachments

  • 001.jpg
    128.3 KB · Views: 193
  • 002.jpg
    99.9 KB · Views: 177
Measure the outside diameter of the ring still on the trans. then go to Brewers Performance website, you should be able to figure it out from there.
 
You might also need to know the size of the bearing behind the retainer. There are two sizes of bearing & three sizes of retainer. I think there are two sizes of retainer that will fit the larger size bearing but not sure about how many that fit the small size bearing. IIRC, the larger bearing will have the number "308" stamped on it. Don't remember for sure but I think the smaller bearing is a 307.
 
Folks it isnt that hard. This is a small retainer ALL small retainers have the 307 bearing behind it. You dont need to look. it is the large retainer that came both ways for 23 spline inputs.

I have one Ill sell for $35 plus postage.

red
 
Yep, broke mine too. I picked one up at Carlisle with a new seal. Mine went while it was in the car, what a ride home that was!
 
You must log in or register to reply here.
-

Back
Top