mtt ET streets

I have a set of lightly used mickey thompson ET streets for sale.

i used them for about 2-3 months at the track before blowing a motor, then realizing this isn't quite enough tread for my new 600 horse engine.

the tires are a 235 60 15 as you can see by the link below, i paid over 400 for the set. everyone has a diff opinion on tread percentage, but i'd call them at least 75% "tread" left. tread is also a loose term on these tires because they are more of a track radial slick than anything.

i ran them on a 380 horse, 480 torque dart. never spun, ran 1.6 60'. and low 12's. they were perfect for my 3.91 gear at the strip. they really didn't see much street use, they were purchased more to maintain the DOT tire class i ran points in.

asking $300 prefering local pickup but i can ship for additional help on cost.
http://www.summitracing.com/parts/MTT-3752R/

they're off the rims now. just throwing out a picture.

How wide of a rim did you have them mounted on?

They come with a spec of tread depth measured in 32nd of an inch. You can find out what that spec is, measure what you have left and you'll have more than "everyone has a diff opinion on tread percentage", you'll have a dead nuts on measurement of what's left. Every single tire that carries a DOT approval has to have tread depth maximum and minimum standards. That's why those tires have tread wear indicators.

still available? where in ohio are you located at?

sorry guys...apparently i stopped getting updates on this thread. they were on an 8 inch weld rim.

i'm in salem ohio..but between mogadore every day for work.

44460
44260

i do have a soft commit on them, but waiting to hear back. i'll be in touch!