Air/Fuel Ratio Gauge

-
superchargeddrt

superchargeddrt

Well-Known Member
Joined
Aug 24, 2009
Messages
2,447
Reaction score
1,210
Location
Pittsburgh, Pa.
Hi Guy's,

Got a few hundred bucks burning a hole through my wallet and I figured that I would finally pull the trigger on a air/fuel ratio O2 gauge. I was just wondering what some of you were using. I'm looking for a complete setup (O2 sensor, gauge, wiring and bung). Thanks for your help.

Glenn
 
I'm interested in this also, do you need a sensor on each side? How far back off the collector?
 
I asked this same question a little while back and got one of the Innovate kits.
Others here use them and seem to like them.

Look around though, because I got mine off ebay cheaper than you get it from Innovate.
I got my set for 156.99 shipped from this seller dfactoryparts even though he has a low sales count and it was here within a week.
Brand new unopened factory box, and comes with everything you mentioned.

I posted all the info recently about sensors and locations, so give me a min to find it and I'll post the link.

Here is the post where we discussed the details about 1-2 sensors, and placement.

http://www.forabodiesonly.com/mopar/showthread.php?t=260079
 
I, too, ended up with an Innovate. Only real complaint is.......the wire lead for the display gauge was way too short, and the supplied gauge was cheap as 'ell. The clamp for holding in the mount was so cheap that the gauge would rotate in the gauge mount. I finally gave up........just let it be "sideways."

Bought an LC-1 on Ebay for around 160
 
You could always send me the money:toothy1:
 
You must log in or register to reply here.
-

Back
Top