360 intake

-
T

Torrance1

Well-Known Member
Joined
Aug 1, 2015
Messages
139
Reaction score
19
Location
Calif
Hi all
I'm sure some of you have installed the 360 intake onto their 318,
any good advise, I have the correct set of gaskets, and the water outlet that is
mentioned. Is there anything else? What about mounting the Air conditioning pump?
Best
 
It will work...

Some people will point out that the ports won't match exactly, but it's not a show stopper and will improve performance...

You may need to tweak the kickdown linkages and also get the proper 4 bbl throttle cable mounting bracket so the accelerator cable will reach... The 4 bbl linkages are slightly forward of the two barrel...

Mancini Racing Throttle Cable Mounting Bracket

You will need to add about an inch to inch and a half more adjustment on the kickdown lever that goes to the carb....

Here's a good thread on 2 bbl to 4 bbl conversion that may help:

2-Barrel to 4-Barrel Conversion
 
Torrance1 said:
Hi all
I'm sure some of you have installed the 360 intake onto their 318,
any good advise, I have the correct set of gaskets, and the water outlet that is
mentioned. Is there anything else? What about mounting the Air conditioning pump?
Best
Click to expand...
you don't need no stinkin' A/C.. :lol:
 
Ben Drinkin said:
Says the yankee that lives in a wintery climate!
Click to expand...
Ahhhhh, it's all relative!
We get to 85 and we're cooking like we're ina stew pot. 90's are crushing, 100's are rare and we drop like flies.

No one up north cares about 110-125 where you are, were are busy scrambling for relief!

Lol
 
Last edited:
If this is a summer ride block the heat crossover passage with small pieces of tin (MoPower)! Then again your in california , to hell with the choke!
 
although I am native Cal, I have lived in both
NV and Az, and never used air. roll the window down
and I'm off.. but since I am going to sell this car
I do want the air to work...
 
You must log in or register to reply here.
-

Back
Top