[Found!] Early A Z-bar for 273 9.5" clutch

-
Status
Not open for further replies.
Yes sir, all I know is they are different. But what is the difference? Is it just the width? What should a 273 bar measure? Are the throws different?
 
Dana said:
Yes sir, all I know is they are different. But what is the difference? Is it just the width? What should a 273 bar measure? Are the throws different?
Click to expand...
Doesn't really matter what the difference is but they are. I see Brewer doesn't have them in stock right now. They find used ones and blast and rebuild to resell. So do you need the V8 one or the slant one?
 
Well Mike, it does matter because if someone sends me one i'd like to find out it is right before I get the car tore apart. The title says 273.
 
Dana said:
Well Mike, it does matter because if someone sends me one i'd like to find out it is right before I get the car tore apart. The title says 273.
Click to expand...
Ah. Thanks, I wasn't paying close enough attention. I will look in my clutch parts box this afternoon and see if I have one. Doubtful through. I think I just re-used mine with new bushings. I will look for you though.
 
Here’s a pic of the one I’m sending, out of a 273 65 Dart and tube measures 7.5” as it says on Brewers Performance website.

7BC0E469-762E-405D-B5AD-49596FB80923.jpeg
 
No problem pal. I was on a shoestring budget putting this car together. So I made a z bar from a bbody. It never has worked very well. I have pulled it and changed the throw which got me closer. If I didn't have to drop the exhaust completely down to work on it, then I would keep working with what I have. Mig wire is cheap. Thank you anyway.
 
Status
Not open for further replies.
-

Back
Top