Rotisserie question- bracing

-
M

mike240

Well-Known Member
Joined
Aug 21, 2019
Messages
279
Reaction score
322
Location
AZ
Ready to put the 66 Dart GT hardtop on the rotisserie.

I will not be cutting and replacing any floor etc. A lower rear wheel arch is all the metal work needed. So the question is do I need to brace the door openings and cross brace? Or will it rigid enough.
 
You should be okay, but it wouldn’t hurt only a few dollars for the material and a bit of your time
 
I screwed a couple 2x4 steel studs across the door openings until I had the subframe connectors in place.
 
If thats all the work that needs to be done it seems like a waste of time to put it on a rotisserie. You shouldn't need any additional support for that repair.
 
MoparMike1974 said:
If thats all the work that needs to be done it seems like a waste of time to put it on a rotisserie. You shouldn't need any additional support for that repair.
Click to expand...
The rotisserie is for more than just body work. Being able to prep and paint the underside easily is a god send with one.
 
Furious65 said:
The rotisserie is for more than just body work. Being able to prep and paint the underside easily is a god send with one.
Click to expand...

I went this route due to too many old injuries and ortho surgeries. It is worth it me and I will sell it when done.

Thanks for responses guys.
 
You must log in or register to reply here.
-

Back
Top