dodgedifferent2

• 

  FunnyOldMan

• Dec 21, 2020

Howdy Mr. DD2, I am another interested person in need of a rear disc brake conv for 489 3.23 sbp 8.75- a body 1971. I can supply email via message if that works for you. Thank for your time and a happy holidayz ;)

• 

  PhotoGreg

• May 11, 2020

Hi, saw your post on Mustang brake conversion - can you send me more information? I am interested in buying a set of brackets. [email protected] is my email.

• 

  stacks

• Jan 6, 2020

Hello DD2 I have read your post about the mustang brake conversion. I would like to purchase one or 2 if you are still making them.

• 

  bcbound

• Nov 8, 2019

I have a 68 barracuda with half tubs, MP spring relocation kit installed and a flat trunk floor. I have a fuel cell in the trunk now but want to hang a tank with a fuel pump where the stock tank was.
Are you into making another tank? I would like to keep the stock fill pipe and flip open gas cap.

• 

  clementine

• Oct 12, 2019

good morning DD2. I would like to get some of your 8 3/4 disc conv. brackets. I am at 98133. How much do you charge? PayPal? email?

David.

T

• T

  theman440

• Sep 13, 2019

Hi There, I would like to buy a set of your brackets. I have money burning a hole in my pocket.

• 

  1968Dart

• Mar 14, 2019

Hi, I was wondering if you are still making the brackets? I’d like to get another set off you. Let me know....
Thanks

W

• W

  W2Nate

• Nov 30, 2018

Hey are you still making the rear caliper brakets?

B

• B

  bbcharger71

• May 14, 2014

Hey, first off. I want to thank you for your awesome thread on the mustang disk brake conversion. I too am doing this on my charger. I have the spacer plates made. I used 11 gauge which is the same thickness of the drum backing plate. I was wondering if all 8 3/4 rearends have the same spacing from housing to flange. If so, could you tell me what thickness and what type of stock you used for the brackets?

Thanks,
Daniel