Search results for query: *

Give em hell, be safe, and God's speed! 65'

So far so good. In the oven for an hour

Steve!! Your stupidity has been redeemed. The fan will blow air the same direction if it is mounted either way. Now for the BUT.... The curved shape of the blade will be more efficient in the correct orientation (orange) "L" is leading edge of the fan blade "T" is trailing edge of the...

Hello from a newbie on the forum. I will be removing molding trim to ready for paint but not sure how they are attached. Any and all info is appreciated. Floyd in Florida

Part #5884

That is basically the same thing I am doing now. I want to go to something with wheels so I can move it in and out of the paint both when the time comes.

Although I haven’t been there for years I’ll check it out. Thanks John. Kim

On Adam-12 today. I'll watch it sometimes just for the old cars that were new then, like the Belvedere. That Mack wasn't new when the episode was filmed circa 1969.

When I did my 66- I had it in the rotisserie and lowered it lower to the ground about 18” on top of jack stands. I shimmed the jack stands (3 per side) with wood and plywood. I leveled out the top of the rockers with this method. When I did the quarters - I was able to cut off and install and...

275 Shipped OBO

Two of these showed up at a local Walmart in the last day or so.

Like the rest of today's vehicles, no style

you're not the only one with sausage fingers, lol. neil.

1 kd lever is about 2 inches the other is 3 inches. What do u have. Post a pic. Kim

Scamps trunk is stuffed with chairs, table, and BBQ grill. I'm still doing lunch for us all and now my car has enough weight in the back for traction. :thumbsup:

Mopar Dodge 727 Transmission Kick Down Lever NOS PN #2899370 ,M880 | eBay part number 2899370 for 727 lenght 2.610 too long has right D...

:thumbsup:

Have the 74 Dart on the rotisserie right now but getting close to the point where I need to get it on to solid ground to fine tune panel fitment, so I have two questions. 1) what are people using for Body Cart that they like? Something like this Auto Twirler Cart. Worst this is I can make one...

Looking for a b body rear end around the Peoria IL area. Prefer 8 3/4. Thanks!

I managed to get the car in the workshop for a few minutes today. It looks as though the kickdown operating arm is very slightly longer than I need for this application. With the throttle closed the kickdown lever is about 1/8" back from fully forward and at WOT the lever could still travel...

In case link not work

Big Bummer :(

❌

13HP Honda? 4 stroke gasoline engine from a power washer. Pump seals failed in washer pump, so now selling the engine. Engine runs fine. Can see run. $100.00.

Good Luck and will be snacks in the basement. IA has some crazy weather right now. storms and tornadoes everywhere southwest of you heading your way from Des Moines

Thanks Troy, I filled block 1st thru the hose connecting 2 nipples on engine, then topped up rad. I'm pretty sure it was a combination of things. The shitty pedestal fan being the major contributor. Engine fan was on backwards also but was in car same way for years. TTI eta is Friday! :thumbsup:

Yes I mentioned the Ultra Low Sulphur mandate of 2006. Just for the record, Prudhoe Bay, AK oil fields had free diesel to stay running. After 2006 mandate, they started hauling 10K gallons a day from Anchorage to Prudhoe Bay - 850miles each way. Cost of that rolls downhill to the end users..

Wish me luck, I'm attempting a Creme Brulee' cheesecake.