Search results for query: *

I have used contact cement [ glue ] many times. I must have been lucky.....

I ran across these new taillight lenses on ebay motors for less than $80 delivered https://www.ebay.com/sch/i.html?_from=R40&_trksid=p2499334.m570.l1313&_nkw=1970+Dodge+Dart&_sacat=6028

OP: re the first photo in your first post. Every rallye wheel produced by Chrysler has this inner and outer ring mounting arrangement. Its been working fine since 1970...

The factory Prospector Hurricane wheels look dang good.

Last time I lived in Virginia, I was working dayshift as a defense contractor, I couldn’t find a swingshift permanent job. Congratulations on your dayshift.

Need a picture of your printed circuit board. There should be three slots where the IVR plugs in.

I've seen Holleys stand 10PSI. They can usually stand more fuel pressure than say a Carter or Edelbrock.

If it wasn’t important Holley would say5-8psi is fine….. but they don’t

no check valve. You seem to have a vent system that is older than your car. up through 1970 the vent was simple and ended inside the rear frame rail. it is actually design not to vent anything out of the tank, but rather let air into the tank to balance the fuel being pumped out. 1970 CA cars...

That's what I thought, all the carsI was getting steel wheels off of for guys who wanted that look. I should have kept one of the trunk release for my self, but I had had my stock one replated so never. I may be a cheap old SOB. Like stated above gold diggers. I like to pay fair prices, and...

Picking one up in the am from a.member

Still available and a quality piece!

Over 100 pairs of heads! Found one #286 1963 Max Wedge 426 Head =$475.00 Looks to be in nice shape!

I believe the trunk floors are the same 67 to at least 72 so I think all A bodies use the same frame rails so that shouldn't matter. I am only going to be changing the rearward most part of the quarters and yes I have given consideration in needing to incorporate the side markers as part of the...

E-383 HP engine 906 heads 10/23/68 Mileage unknown. Turns over. No carb or exhaust manifolds. Located in Western Maryland $750

however much you want, the confines are only the physical limitation of the camshaft itself. you can only slice so much cheese off the block, ya know?

OP - how many rods in your kickdown system? The thing that really has me puzzled is that everyone is giving you solutions to make sure that the lever on the trans is all the way back at WOT, but you are already achieving that, right? I agree with you - the issue isn't in the linkage. If the...

I thought that it would. Do you know how much it changes it?

Send me a PM

I have a set. Not sure if I have an extra.

I used a product from POR-15 called 'patch'. Worked well, so far. Fillers and Putty

thanks!

Also, clean any dirt and rust off the fingers on the socket and around from the hole where it installs. These areas need to be bare metal to conduct ground properly.

72 duster emission canister/bracket $40 plus 17.10 shipping.

It changes it.

1970 A body 340 rallye dash bezel no broken tabs and $300 and plus shipping.

I hear about having a cam reground. How does that affect the cams original lift and duration

OP - I hear your issue, I just approached the spare need in a different way. 245-60-14 in back and 205-70-14s in the front. The tires are the almost same height due to difference in profile. This also makes the fronts and backs look the same when viewed from the side of the car. Then I found...