Search results for query: *

The lifter gallery is a great place to bleed off oil pressure for sure....

Looks like that....

Built when stuff worked....

Thank you, I will buy. Thanks

Thank you......I do not see where it shows a MSD stand alone dist......It might work.....

O sparkly

I WAS going to say, leave it like is if you like the sound of metal on metal crashing sound....

Do you know if this can be used with any other Dist?

Holy Hemi's Batman, over 15 Million Views on our little BS coffee thread!!! @toolmanmike looks like you have a winner!!!

This.......

Hey @halifaxhops you want me to send a pass to the captain?

Same way but with coller clamps in exactly the spots I cut...

Well there it is

I have some very old gear wrench. Big difference is the number of teeth..

With steel fuel line..

All of it?

So the steel fuel line is grounded with an attaching bolt. Then there is a clip on strap that completes the ground circuit.

I modified this for 4bbl

Well got that out. Only 3 cuts

This

Getting close. Needed that 9/16 gear wrench to remove bell housing bolts. Actually the belcrank that bolts to the rear of the left head. Not needed any longer manual shift But in the way..

Guy who invented a gear wrench should get a Nobel prize...just saying.

Only issue with Hagerty with me was must be garaged.....

Haggerty for the win!!! 30 K value on my 66. 150 a year!!! No limits on usage as long as you have other cars registered, Not primary vehicle... Changed from 25k to 30k before power tour, went up by 9 dollars a year!!

Not this year. Just truck at show. Bringing car trailer to Hoppys, have a paying load to Mark, a friend of ours...

I went to lowes and replaced it...thanks...

Unfortunately they are all the same. Put a nice bead of black RTV in the groove that goes over the pinch weld, install gasket onto car, use blue masking tape to hold top in place, then let sit about 2 hours, then install glass and lock strip. No leaks at least it worked for me...

Lunch. Oggies

Got credentials