Installing Weld in Subframe connectors on my Duster, checking the E-brake cable I found that it comes in contact with the side edge of the subframe . Looking for pics of other install how you addressed the E-brake cable and any concerns with the Gasline and Brake lines. I will be installing new...
looking for 11 in brake parts the e brake lever and c clip also the spreader bar that the e brake is part of. Hope that my description of the parts are understood if not please pm Thanks
I pick up a B Body rear end for my A Body Duster yes for the large bolt. I realize that the spring perches will have to be relocated 1/2 in. I checked the spring perch they seem to be 5 degrees off towards the front of the car, or the pumpkin when installed on the car, is this correct? Has...
I am in the collection of parts from a slant six to a 340 swap for my 1970 Duster. I have a 727 Transmission for which I plan to bolt up to the 340. My question now I am looking at the transmission cross member will the cross member have to be replaced? The cross member on the car appears to...
I have a 340 crankshaft and would like to know if it is a cast or steel crank. I looked for a casting number no luck, the only numbers that i could locate were a 50 in a triangle with a capitail R above. not sure if this means anything to someonethanks in advance for any help
considering the purchase of a high flo oil pump for my 340 or should I be satisfied with the stock oil pump. will it cause a low oil level in the sump. the high flo require a larger capacity oil pan, also does any no of a modification on oil flo to the number 6 cylinder thanks
bought a 340 block and crank 12/10/68 ,clocks indicates D, hand punch 9B331245, also located at front eng, L5 and R8. What I do no Dec/10/1968. not sure about the crank V 50 it has a 1/8 groove along it, any info would be greatly appreciated thanks