Search results for query: *

Thanks.

K. That didn't help me much I'm afraid. I wonder if you could tell me how far the alternator is from the valve cover? I remember is sitting further forward before I took it all apart. Thanks anyway for the pic. RedYeti

I didn't! Can you post a pic of your alternator braket with all of the spacers and whatnot? Thanks. RedYeti

All the help is appreciated. I moved the regulator wire from the '+' coil side of the resistor to the 'key side' of the resistor. That solved the problem. I should not have touched the '+' side of the resistor. You guys are a wealth of excellent info and I appreciate your help. My cuda is...

Man, I really appreciate your coming to my rescue, but I simply don't get it. What is the KEY SIDE???? I am way beyond just doing anything. I have everything disconnected and obviously broken. Could you confirm which side of the ballast resistor each of these goes???? RIGHT SIDE of...

I have a question on this. I have a 68 Barracuda. Could you show me on this diagram where the voltage regulator plugs in? Is it in the same place where the yellow is diagrammed here? I just installed the Proform 66991 and my car will not run. I have the blue wire in the right spot, but the...

Thanks for the replies. I found the problem. The fusible link blade inside the plug was disintegrated. I spliced on a new blade and cleaned up the plug, and we're alive again.

All was well. I finally got my heads, intake, and new carb all installed and was setting the timing and whatnot, all was well. I came back to it later, and nothing. I have power here: Nut on the relay Nut on the starter Both sides of the fusible link I don't have power here: Nut on the...

Brilliant! Thanks.

My vacuum advance touches my oil sending unit and shorts it when timing is at 10* BTDC. Anyone else see this? I put electrical tape over the connector, but that won't last. That idea about using a sleeve to protect the spark plug wires is genius. Thanks.

After trolling around for a while reading suggestions about upgrades, I chose the following for my 68 Barracuda: Edelbrock Thunder Series 650 Edelbrock Performer 2176 Hedman 78050 (what a PITA to install) Starts and runs. Has an intermittent exhaust backfire. It almost sounds like it...

I want it. Could you pm me you tel # and i'll give you a call.

Here is my wish list, for now: For notchback. Heater air box for NON-AC car. Drivers side quarter window regulator, with all the little plastic wheels intact. Rear seat That's my starter list. Any help is appreciated.

SNAP! That notchback thread is killer.

I haven't been around the Mopar groups for a while, and I see that most of them are gone. Even the Paddock?? What gives. I just picked up a 68 Barracuda in ok condition. Original drivetrain, runs and drives, well, newish tires, currently registered and insured. I'll need to do some body...

Hello all, I need a complete one. Condition is unimportant. Please respond to this thread with what you have. Thanks!