Search results for query: *

I currently have a b&m unimatic shifter installed in my duster so it already has the look. But I'm wainting a nice hurst pistol grip. Has anyone on here ever adapted the hurst shifter on the b&m base? I've seen it once before but now can't seem to find the link to the write up.

I just recently bought a Holley 4150 hp series 750 from a local carb guy. it's been rebuilt and I was told should perform well on my mild 446. It takes of fine but as soon as I get on the throttle it starts to spit and have a back fire. Timing is set at 38* a 3000k. Running a single plane tm7...

Ok so I need a good rad to cool down my mild 440 I need opinions on a the two rads I have in mind. http://cgi.ebay.com/ebaymotors/New-Afco-Universal-Alum-Ford-Mopar-Racing-Radiator-27-5-/130545590891?pt=Motors_Car_Truck_Parts_Accessories&hash=item1e651fa26b#ht_3443wt_762 The second one...

When I bought my duster it had the drums up front but had this disk setup in the trunk now the upper ball going is the small one and it does fit my bakes as well as the the balljoint for turning, but the lower balljoint is huge amending fit my lower control arm, if some one can tell me what they...

I'm getting ready to have my driveshaft shortened for my duster now I have the slip yoke and driveline on a old sportsman rv with a727 wich has a 4" diameter tube same as the trucks I believe, has any one ever used this big of a driveline in there car? I have the original slant 6 driveline I...

I recently picked up an early ford Dana 60 from a 1964 ford f100 the specs as far as dimensions go drum to drum measurements are identical to Mopar b body Dana 60, the only difference is the perches and the Lug pattern it ls 5x5.5. Has anyone ever used these danas without narrowing them and...

My oil pan has numbers on it, anyone know what type it is? It has a windage tray and came of a 69 440. I've attached a picture, trying to see if it would fit my duster and clear the steering arm. Thanks. http://i101.photobucket.com/albums/m69/adrianp_01/1298485364.jpg

I pulled the cam out of my 440 it's a crane fireball cam. It says 294 on it. On the bottom side it has the numbers:65-25-84. I know it's an old cam. Does anyone know the specs on it. Tried online but didn't find too much info on it. Thanks guys

Ok I just scored a sweet deal on eBay I bought a tunnel ram complete with 2 Holley vacume secondary carbs for 325$. Any way I have a 77 440 engine that's rebuilt to stock specs still low comp and bored 20 over. The engines in perfect shape so I don't really want to replace the slugs. I'd like...