Search results for query: *

Slant 6 exhaust manifold, PN: 2268960-7 No Cracks, heat riser is stuck open. $25 + shipping from Hamilton, OH or local pickup

Slant 6 intake manifold PN: 2205901 $30 plus shipping from Hamilton, OH or local pickup

Slant 6 transmission and torque converter. Ran and shifted well when pulled from a '68 Dart 8 years ago. Hamilton, OH. $75

Big Block 727 from a '70 383 Cuda. Needs rebuilt. Hamilton, OH $100

(4) 13" wheels and tires off of a '68 Dart. Tires are too old to drive but may be fine to roll around a project car. Sorry no shipping, but might meet you halfway if close enough to Hamilton, OH just north of Cincinnati. $30

Three P175/70R13 and one P175/80R13 mounted on stock steel rims. They held air 5 years ago when I drove around a '68 Dart, but the tires are in bad shape. For pick up only, on the north side of Cincinnati, near Hamilton, OH.

Two P235/60R14 and two P195/70R14. Tread is like new, but they were made in 1999. For pick-up only, north of Cincinnati near Hamilton, OH. They seem too good to throw out, but I just want them gone.

'74 Dart Sport, 225 with factory electronic ignition & ballast resistor. How hot is normal for the ballast resistor? I turn the key to the run position, and feel it warm up within 30 seconds. After a minute it's almost too hot to touch. Grounding issue? I improved the ICM ground to the inner...

I almost have the heater core out of my '74 Dart Sport, but the console needs to move back about 4 inches to slide it out from under the dash. I removed the two rear mounting screws that are accessed from the storage compartment. I can lift up on the back a few inches, but it is attached at...

It's scheduled assembly date was May 3, 1974. Winter improvements include a re-cored original radiator, all radiator & heater hoses, rebuilt the leaking PS pump, replaced rubber fuel lines & filter, tune-up, 4-wheel brake job, trans fluid & filter, oil & filter. The Kelly Chargers look good...

1966 slant 6 904 w/converter, ran & shifted well when pulled a year and a half ago - $75 Located in Cincinnati, OH

The original radiator on my survivor Dart has a small leak at the water inlet. I want a Chrysler radiator to go back in, and not an aftermarket replacement. To repair the original is expensive. Anybody doing a V8 swap and looking to unload a leak-free A-body slant radiator?

1-bbl intake/exhaust manifold from a slant 6 heat riser rusted shut. $10, located in Cincinnati

Set of 13" hub caps from a '68 Dart. $50 plus the ride from Cincinnati, 45011 All 4 are in nice shape. Thanks!

Set of 13" wheels and tires from a '68 Dart 4 are 175/80R13, 1 is 175/70R13 $50 located in Cincinnati

Slant 6 904 trans for sale. Ran and shifted well when pulled. $75 located in Cincinnati. Thanks!

904 ran and shifted well behind the slant 6 when pulled last October. $100 includes stock converter. Located in Cincinnati, OH Thanks

In my '68 Dart I recently installed a good running '66 225/904 that came out of a '66 Valiant. My Dart is an original 225 car. The center link is only about 1/8" from the oil pan directly in line with the oil drain plug. Does anybody know if an A-body V8 center link would add some clearance...

Hi, I am looking for a good running 225 for reliable daily driving for the '68 Dart in my Avatar. I already have a good 904, but I'd be fine installing a 225/904 combo that already runs & drives well. I am in the Cincinnati, OH area. I saw the one in MI, but it's a stick. The one in FL looks...

1966 225 short block, block casting# 2463430, std bore, ran when pulled last Oct. - $40 - Compression checked well within specs. Didn’t burn oil. - All other parts were pulled off the engine. Let me know if you could use anything from it. Located in Cincinnati, OH. Thanks

Almost new slant 6 parts: Starter, Napa reman. - $30 Holley 1 Bbl, reman. - $50 Single point distributor, rebuilt - $25 Cap, rotor & wires - $20 Carter fuel pump - $15 Dayco Top Cog belt for no AC, no PS - $7 Many other parts pulled from the '66 225 engine. Let me know if you need something...

2” Walker Muffler P/N18237, 18” long x 9” wide x 4-1/2” tall Paid $45, clamped it on, drove it 300 miles, and changed the plan for the car. $20 + shipping Located in Cincinnati, OH. Thanks

Only 300 miles on a new Murray slant 6 radiator & hoses. Decided on a V8 swap. Includes cap & new trans fittings. Cost $240 new. Will sell for $160. Located in Cincinnati, OH Thanks

Ran and shifted well when pulled in October. $50 includes stock converter Located in Cincinnati, OH Thanks

1966 225 short block w/pan, casting# 2463430, std bore, ran when pulled last Oct. - $40 - Compression checked well within specs. Didn’t burn oil. - All other parts were pulled off the engine. Let me know if you could use anything from it. - Air cleaner, hose, & oil fill, almost new paper filter...