Search results for query: *

413 8.3 compression 5 Speed manual trans 3.00 independent rear end 3000 lb Cam specs are an estimate The Max pipe software calls for 47.5 inch primary tubes for 5000 rpm peak horsepower. What is a good max shifting RPM for the 413 or 440.

What would be a good strong rubber mount for big block to hot rod frame.

Does this look like a crack in the picture

I need a bellhousing flywheel clutch pressure plate. big block to TKO 600 chevy trans

i need a cluch and flywheel for the 273. does the 360 bell fit.

The topic says it all what is the thing on the valve cover

Where can I buy this Copper poly paint for my 65 Barracuda? code HH1

Is one better than the other

The are RN has a bigger hex and slightly taller. Any problems with one versus the other

1956 Barracuda what pump should i use. don't want Electrical pump

Help me with my colors everything is stock and original with a little work to the engine. Wondered if I should go original color. Or go red white and blue like my engine. Engine Bay black?. Would it have better value being original color or does it really matter

904 input shaft clearance. is a .120" too much. Can I use 2 thrust washers instead of one

I have 65 dart and 65 barracuda 904 trans. accum piston & spring. Can you tell me what effects from the different ways. I think it has to do with shifting into low gear how hard it hits. Image from the 904 transgo T1 shift kit

Which piston is better I have a 65 Dart and a 65 Barracuda Is the bigger spring better than the other one.

This gasket set was for a 273. The intake on one of the heads seems to be a bit off center The gasket is barely catching the edge of the divider between the ports could this be something like casting shift. 273, 340 Both have 48ﾟ angle. 65 273 intake has 5/6 bolts not drilled at 90ﾟangle.

bored 30 4B Victor 340 intake

looking for 65 Barracuda 273 4B intake, carb, timing cover, oil pump, fuel pump, dist,coil, water pump, plugs and wires, motor mounts

what do you think about my setup. it runs and idles good at 800 rpm. its very street-able. I think I may want a little more cam. any suggestions This is my Daily Racer (Daily driver street machine). more of a road racer than a drag car. I like to go fast around corners and turn both right and...