Search results for query: *

I`m looking for a 4 gauge bezel for 2inch gauges.

I am trying to figure out what diameter the pulley should be for the Saginaw pump on the L.A.360 in my 67 Formula S Barracuda. Any ideas? Thank you. I just noticed this the big block forum. Let me know if I need to delete this.

I need the fasteners for the trunk lid chrome for a 67 Baracuda. There is fourteen for the upper and lower-7 ea. and six for the wide one. Thank you. Patrick.

I am putting a 360 out of a 1978 Dodge van in my 67 Barracuda. I went with a 273 water pump so I could use the original radiator The car had a 318 in it but it came with a 273. I am now having problems with the power steering pump not lining up. No where to bolt it up to. Can any one help me out...

Any one have a set of 67 barracuda S hubcaps? they sort of look like a five spoke mag. Thank you. Pat.

I started the 360 and oil pressure went up to almost 70 lbs.for a few seconds. Then started to dive to around 20 lbs. I shut it off before it had a chance to go any lower. Does any one know what may be happening? Thank you. Pat.

Does any one have a picture of correct placement of timing marks on a 360 timing gears. I am trying to make sure every thing is correct as some one has done most of the work on this motor. Thanks Pat.

Does any one know the diameter of the power steering pulley for a 67 barracuda 273? Thank you. Pat.

Any one selling a 55 Plymouth 2 door sedan or hardtop?

Hello mopar fans, There are some cars that may be of interest to somebody. They are on Craigslist Phoenix Arizona. Listed under cars and trucks by owner only. Key word station wagon in the search bar. Good luck. Pat.

I would like to find two wood grain steering wheels one for 65 barracuda and one for my 67 barracuda. Pat.

I am looking for a 360 oil pan preferably from a car that will go into my 67 barracuda Thank you. Pat FOUND ONE. Thanks every one.

we are putting a 360 from a 1978 dodge van into my 67 barracuda conv. We removed the pan from the 360 and installed the pan from the 1972 318 that was in the car only to discover that the rear pan sealing area is larger on the 318 pan leaving a gap to large to seal up can any one offer a...

I am in need of a wind shield rubber or gasket or what ever you may call it for my 1967 Barracuda. New if possible. Part #wbl690 Thank you. Pat Found it. Thanks to everyone. Sorry that I didn`t mention it is a convertible. Pat.

I need both rear armrest pads prefer black and both visors. Thank you. Pat.

I have two Mopars that I am thinking of selling. I have a 1965 Barracuda a slant six car. It has a rebuilt motor with a two barrel carb. I have put complete suspension from a 1973 Duster. I has manual disc breaks and ten inch breaks on the rear. It needs upholstery work. It is all there but in...

I am looking for chrome that is located at the top of the quarter panels just below the rear seat roll up windows. 1967 Barracuda Convertible only. I need both sides. I am located in Phoenix AZ Thank you.

Hi everyone! My name is Pat I have a 1965 Barracuda and a 1967 Barracuda convertible. Looking forward too communicating with other folks with love Mopars and all classic cars.