Search results for query: *

Thanks - will give it a shot

Anyone have or know where to get this corner trim piece for a 1965 Dodge Dart 270 Convertible? Appreciated

How do you or is there someone who can refurbish the steering wheel center cap for a 1965 Dodge Dart? The clear plastic part has cracks through it. Thanks

Anyone install rear speakers in a 1965 Dodge Dart Convertible? Where? Pictures are appreciated Thanks

Thanks - Love your comment "If I needed any other music than a nice sounding engine"

Thanks - sent a message to 66dvert

Has anyone installed speakers on the door card of a 1965 Dodge Dart Convertible? I am looking for best placement (front or rear of door), tips, pictures, etc. Thanks

Charrlie_S - yes they are 10 inch - did not think of that

So, I may have to resort to leaving the 5x4's on the front with the hubcaps and getting "non-hubcap" rims for the rear with the 5x4.5 pattern??

I am looking for 2 13" rims with a 5x4.5 bolt pattern that I can place the original hubcap from my 1965 Dodge Dart on. Anything out there? Thanks

So I will need to modify the floor? Jeez Have to review that with the mechanic! I know we are going to put the shifter on the floor so I guess it would be modified anyway.

Thanks for the input all - I am new to the transmission area I will research your comments and try to get up to speed I am not sure what the "tunnel" is". Is that the part that in the engine that the shaft from the transmission goes into? Like I said, I need to get up to speed

I have a 1965 Doge Dart with a 360 engine and 8 3/4 rear. It is currently a 3 on the tree and I want to switch to an automatic. I come into a lot of stop and go and, call me old, I'm tired of all of the shifting. I just want to cruise. I was hoping to go to a 5-speed automatic instead of the...

I have the Speedhut gauge, but since it is a top mount, I will not be able to use it. I am not looking to modify my trunk at this time as redfish suggested.

1965 Dart - in the philly area

Is this still available? Do you have measurements flange to flange and mount to mount? Thanks

joe440 Do you have the measurements from flange to flange and from mount to mount? Thanks

toolmanmike - the ohm range will vary depending on your vehicle and gauge (original vs after market). I have the Speedhut fuel gauge so it says I do not need to calibrate it to the Speedhut sending unit. The important thing is the length. I think the 65 Dart is 8 inches, but don't quote me.

Speedhut Fuel Level Capacitance Universal Sender (3.5" to 12") Summit Racing https://www.summitracing.com/parts/cin-sn35t7?seid=srese1&cm_mmc=pla-google-_-shopping-_-srese1-_-classic-instruments&gclid=EAIaIQobChMItcGh5aWq1gIVUWF-Ch3eUAeLEAQYASABEgIGCfD_BwE

Pishta - Still trying to figure that out

I am looking at putting a floatless fuel sender unit in my 1965 Dodge Dart. I am looking at the one from Speedhut but also saw them on Summit Racing. I was wondering if anyone had any experience with this type of unit. Thanks for any input

Is this still for sale?

Hello baracus, How does the unit run? When was the last time it was run? Is it all original or rebuilt at some time? Thanks

You got that right - it's all about the cruise (but a little punch just for fun)

Thanks Nileswine Last year I went from the original 273 to a 360 One year will be the rear, 15" (or more) tires, & disc brake conversion Only so much to budget in a year

Thanks 65 Dartman I think I am going to go with the GPS speedo/tach from Speedhut I just need to check the dash to see how to make it fit

Thanks prrc

The gauges from speedhut look nice - anyone have experience with the gps gauges? what happens if they lose the signal?

BTW - Sorry I did not reply right away - I was supposed ot get emails as people post but I have not received any

Thanks for all of your cometns. The speedometer runs but does not light up at night even with a new bulb When the GPS says I am doing 60, the speedometer says I am doing 70. the faster I go, the more it is off. If I do 40, it may only be off 5 mph I took the car for a ride. When it was...