Search results for query: *

More photos

I’m listing this for my dad. This car is a roller with a 8 3/4 under it, center section has been removed was a 340 car with A/C, needs engine, transmission and interior. Car has been sitting for years and has panels and hood that need replaced. Time and age require a sell. He’s asking $5000 OBO...

Rebuilt 340 with mild cam. Rebuilt 904 transmission with reverse manual valve body. Air gap intake. Holley 750 double pumper. MSD ignition and distributor. Rebuilt 8 3/4 suregrip rear with 3.91 gear. Front suspension new. New brakes all the way around. New Goodyear tires all around. New aluminum...

Ok thanks. I never did anything with them other than take them out of the box and install. After I saw the leak, probably from needing trimmed around the intake runners, I saw this. When I removed them to address the leak. thanks for the replies!!

Is this normal? Took them off to seal up a leak around the gasket and saw this. They’re cast aluminum mp. Both cracked in the same spots.

No it’s a open gear set

Thanks

Housing which has been cleaned, scuffed and paint chassis black, gears, Axles

Okay. This is all new to me. The guy that rebuilt my transmission put that on. At first I thought I may need to have the DS cut. I think I may have enough room with that seal, I didn’t realize there was room between that seal and the rear of the transmission. Thanks!

Here’s my question, the DS fits and goes in, however I’m not sure I have enough room between the rubber boot and the yoke. Any ideas or opinions of this looks normal?

Thanks guys

I’m looking for someone who has the same setup to give me a measurement of their drive shaft. When measuring does the car need to be on the ground? Asking because it’s hard to crawl under if not jacked up on stands. 1969 Dart custom Small block 904 Transmission 8 3/4 in stock position Thanks

Thanks guys bought some off here

Pm sent

It’s a highway gear. No sure exactly, it’s a 2. Something. fyi shock plates are sold.

Big bolt pattern. Yes pin is in place

Complete Mopar 8 1/4 or 8.25 rear end out of an 69 dart a body. Shock plates and u bolts with nuts included. Drums and backing plates not included. Located in Akron, Oh 44319 $300

Hi, how much shipped to 44319? fyi your inbox is full.

Looking for a pair of 8 3/4 shock plates. I’m in Ohio 44319. thanks!

Interested pm sent

5x4 SBP 8 3/4 AXLES with green bearings. They came out of a housing I’m reusing which was full of gear lube. Located in Akron, OH 44319. $200 obo plus and shipping it fees.

I have a nice set with green bearings installed. I’m in Ohio.

Yeah I though I uploaded them the other day. I guess not

Took off motor and stored in basement for the last 1-1.5 years. Ran fine when removed, selling due to upgrade. $150 obo plus shipping and PayPal fees.

Okay I’ll see what he says. Thanks!

Hello I’m looking for two c10 seat belt bolts. I’m located in Akron, OH 44319.

Pm sent id like 2 c10 and 2 c12

Make me a reasonable offer

This is a very nice top quality piece made here in the USA. I have a local upholstery shop that makes them for me. All bow sleeves are sewn in. Job fell through that this was for.

Make offer need to sell $185?