Search results for query: *

I just finished my 8.8 swap. Going from stock 2.76 to 3.73 gears. I have a 71 dart with 318 and a 904. Have several upgrades on motor thought lower gears would make up for lower torque 318. Think the tranny is stock, I serviced it when it was out of the car. New oil an filter. There was some...

Ok so I have a 71 dart with front disks rear drums. Brakes were good when I got it, (I mean pedal normal feel and stopped good). Saw pads were low and MC lid leak, soo decided to do all brakes. First rear shoes and turned drums. Drove car all was good. Pulled it in to do fronts. Needed new...

I cant believe how hard this is to get new rotors. Everyone sells a (behind the hub) but no hub. Mine are one piece. these are stock 11'' 5x4 rotors. Any one have a link. None of the part stores list them.:wtf:

After my first startup/cam break in, the carb needed rebuilt due to old gas. After carb rebuild it ran much better. I am around 12 before on my timing. it still loads up at idle and will occasionally spit back through the carb. The quick fuel carb has 4 adjustment screws and with my vac gauge on...

So put the motor together today and got to the valve train part. When I bought this it had bad lifters and a wiped cam and bent pushrods. I repurchased the same parts assuming PO did not adjust rockers properly. Well I'm using edelbrock 6077 heads. with edelbrock 7177 cam. The heads say to use...

I decided to just buy a new pump since everything else is new. They look the same one has a straight arm an the other has curved. Side by side looks like the flat that runs on the eccentric is in same spot. Also my old one I cant hardly pump by had....the new one is super easy to pump. Are they...

71 dart 318 using mostly What came from PO. Wanting opinions on what I'm doin. this is what I'm using. 318 .030 over Edelbrock 6077 RPM heads Edelbrock 7576 RPM AG Edelbrock 7177 cam Quick fuel 650cfm carb. MSD 8534 dist. MSD 6520 6+ ingnition MSD 8207 blaster ss Edelbrock water...

So I was getting ready to put my rings on an assemble the engine, when I noticed a small crack in the piston skirt. Pretty sure it happened when my dad pulled them out. I didn't want to chance it so I ordered a new one. The problem is the part # on the old one is now changed. These are lower end...

Hey All, I just want to say how much I respect and appreciate all the knowledge an experience of all you Mopar guys. Just got my 71 dart project. I've had a 72 and a 69 when I was younger. Super happy to get one again. I'm in vegas an thought parts would be easy to get...I was wrong. Anyways...