Search results for query: *

  1. Braunsteina

    Stop in for a cup of coffee

    I believe the switch mounts under the dash, it was similar to the map lamp on the passenger side below the glove box for the 65 SS. I will look for my service manual to see if I have an image.
  3. Braunsteina

    64 instrument cluster swap into a 65 barracuda harness question

    Attached is wiring diagram for the 65. I will find one for the 64 and compare the two. Thanks again
  4. Braunsteina

    64 instrument cluster swap into a 65 barracuda harness question

    I took off the cover, it is the same there is a single indicator for the turn signal in the center of the instrument cluster. There are two pins for both boards. I am confident that the turn signal will not be an issue. I was thinking I can ohm out the leads from the connector plug and trace...
  5. Braunsteina

    64 instrument cluster swap into a 65 barracuda harness question

    So will this make a difference is the only thing I would need to know. Will it cause me any problems if I were to just swap the pins for all the other components. I have a feeling the system will still function properly just by pinning out the system to match up the pins with relationship to the...
  6. Braunsteina

    64 instrument cluster swap into a 65 barracuda harness question

    My 65 barracuda instrument cluster needs help. I purchased a 64 Cluster part number 2427427 and it had 9 pins on the connection to the board. Mine is 2496508 and it has 8 pins. I ohm'd out the 8 pin board as reference and see there are a few pins that must be swapped. But thinking about this I...
  8. Braunsteina

    [SOLD] 1964 Barracuda, all interior parts for sale

    Yes I did, and I have had mine for almost 9 years and just started restoring 3 years ago. Thanks ;)
  9. Braunsteina

    [SOLD] Left over 66-65 cuda interior parts

    Any 65 headlight bezels available? Thanks
  10. Braunsteina

    [SOLD] Parting 65 Barracuda 225/3 speed manual

    Head light bezels sold? Thanks
  11. Braunsteina

    [SOLD] 1964 Barracuda, all interior parts for sale

    In WA as well, and just hope to track down some parts, headlight bezels and a few other trim parts.
  12. Braunsteina

    [SOLD] 1964 Barracuda, all interior parts for sale

    In need of drivers side Fresh Air Vent and dash pad for a 65 Plymouth Barracuda ;) Thanks
  14. Braunsteina

    [SOLD] early a body heater box,blower, core

    Is drivers side fresh air box in tact, is it available ;)
  15. Braunsteina

    [FOR SALE] '65 and earlier A body speedo cable

    Gears are based on the transmission side, do you know what size Transmission the cable was removed from. Also I have a 65 and there are two different speedo's that can be in the dash, 80 mph or 120 MPH, so identify both ends may help.
  16. Braunsteina

    1965 Barracude rocker moulding clips

    Rick Thank you, great info. v/r Al
  17. Braunsteina

    1965 Barracude rocker moulding clips

    Along the lines of our present discussion, Most of my clips for my 65 barracuda rocker molding trim are still on the car. How do I get the center plug out in order to remove the clips without damaging them. Any ideas, suggestions are greatly appreciated.
  18. Braunsteina

    1965 Barracude rocker moulding clips

    Rocker Panel Clips
  20. Braunsteina

    1965 Barracude rocker moulding clips

    Hi, do you still have the original clips for the 65 barracuda rocker molding fasteners. Thanks
  21. 1965 Plymouth Barracuda 318 upgrade

    1965 Plymouth Barracuda 318 upgrade

    My 318 rebuild ;) lots of work to get her dialed in. Converted to MSD Electronic ignition due to points kept closing and failing.
  22. Braunsteina

    [SOLD] 1965 Backup Lens Set - Valiant/Barracuda

    I know the post is old, are these still available thanks
  23. Braunsteina

    [SOLD] 64-65 Headlight Bezels

    Do these still exist? I am searching for a pair. I am local
  24. Braunsteina

    [SOLD] 66 A body manual steering box

    Did the steering box sell yet? Thanks
  26. 1965 Plymouth Barracuda

    1965 Plymouth Barracuda

    My 65 Resto-mod, the finish will be pearl white. A rebuilt 318, 8 3/4 rear w/ 1:3.23, original A904 LA transmission. Keeping it simple and want to drive around the local car shows. Was my daily driver for 5 years and decided a few years ago it was time to start restoration on her. She will be...
  27. Braunsteina

    [FOR SALE] More exhaust manifolds

    I was able to get my original manifolds back. I won't be needing anything, Thank you
  28. Braunsteina

    [FOR SALE] More exhaust manifolds

    Gil, I have a AT on the floor, no power steering(arm-strong), the motor is actually from an 81 Chrysler Cordoba, Original motor was removed before I purchased the car. All original on the motor mounts, I just replaced them. No mods desired, want her to be a parade car, just a weekend driver...
  29. Braunsteina

    [SOLD] hundred of mopars being parted out

    I live in Western WA, I am in need of exhaust manifold set for 318 for a 65 Barracuda. I guess the 273 V8 commando would be the reference. Please let me know if you have any old sets and we can work out a deal. thank you v/r Al
  30. Braunsteina

    [FOR SALE] More exhaust manifolds

    I have a 65 Barracuda with a 318 in her. I need a replacement set of manifolds. My originals went away to a friend. Then I found out my headers don't fit the 65, Please let me know if you can help me. Thanks Al, I live in Western Washington
  32. Braunsteina

    Best place to order carpet from?

    I purchased my carpet from E-bay Tamraz's is an excellent provider of materials.
  33. Braunsteina

    Help Needed With Reverse Lights

    That helps. i am certain I will be able to resolve it. I will begin tracing wires tomorrow am. thank you
  34. Braunsteina

    Help Needed With Reverse Lights

    I looked at the wires and presently put in a local switch, bypassed the floor shifter switch. Ran it directly to the fuse box - then to switch - then to the lights. When I shift into reverse, I flip switch manually and back up. It works for now. I can revert if I can identify the connection you...
  35. Braunsteina

    Help Needed With Reverse Lights

    Bill, I will check my connections on the switch. I just converted to a variable speed wiper motor and switch. I have a wire which I connected to the post annotated as "B" on my wiper switch. It was not connected and may have needed to be on my fuse block. I will connect it back to the fuse...
  36. Braunsteina

    Help Needed With Reverse Lights

    I have a 65 barracuda, my reverse lights don't work. I have tested my switch which is located in the shifter. Where is the power originated. I have looked at my service manual and I can't identify the originating point for power. I have tested my wiring from the connector on the floor, drivers...
Back
Top