Search results for query: *

Looking for a Barracuda 69 right grille and bezel. With no turn lights or headlights. Good condition. Have 350 dollars. Shipped to 78852 eagle pass Texas Best Regards!

hello Looking for a barracuda 69 right side grill and headlight bezel. I have 67 grill (restorable condition) to trade for. Also have cash Regards!

No thanks, i have one too. Only the cams REgards

Looking for a set of cams. It slides over a square rod that runs through the lower part of the seat back. The cams are attached to the rod with an allen set screw. The cam lifts the locking release latch when the seat release lever is pulled. Regards!

I need a set, too. Do you still have it barracudakit?

the distance of the left side collector to the ground is very short!

Looking for driver side rear seat hinge pieces. Regards

Pm sent again! Regards!

Pm sent Regards

I want (the heavy one) driver side. The heavy one is bolted to the car. Also all the piece bolted to the seat (driver side too) Regards

Im interested only on the hinges (complete mechanism) Would you take $40 for both sides?

Fastback? Do you have pics? Regards!

Looking for fold-down mechanism (complete hinges) only. Wondering if you take $50. Regards

thanks!

Hello I am looking for 2.5" overaxles tailpipes for a barracuda 69. Regards

Thanks!

Thanks, i already have all the pipes except the over axle pipes I dont want to buy a full kit Regards

Hello We have a Barracuda 69 I am looking for 2.5" tail pipes, that goes over the axle diff. I saw it that flowmasters sells but only for B-Body Anoyne knows where i can find them? Regards

Hello We have a Barracuda 69 I am looking for 2.5" tail pipes, that goes over the axle diff. I saw it that flowmasters sells only for B-Body Anoyne knows where i can find them? Regards

I am thinking use a bigger fan spacer. At least a bigger one enough to restore the original (that i had with the previous radiator) distance between the pulley and the radiator

Hello folks Excuseme my bad english, i need your advice Recently we repair my 318 engine. I put 265 dual energy comp cam, flat top pistons, stock magnum heads with hughes springs, msd 6T, edelbrock 600 cfm carb and hooker headers. I remove the stock 69 radiator and replaced with a 3...

Thanks!

I am wondering if a 440 1976 would fit under hood without cutting it. of its a barracuda 69 It has a edelbrock performer intake 2191 edelbrock carb and filter. I dont want to cut the hood Regards

Woud you sell only fold down mechanism?

Which is your best price of the inktake shipped to 78852? Regards

I have a 318 la with a magnum heads swap. Coul i use this harness if i buy intake and computer? I also have a 95 magnum complete engine that would be a donor Regards

Would you take 15 shipped to 78852?

Hello Intake shipped to 78852? Best regards and thank you!

I have a good set of 308 swirl port (from a 360) heads

do you still have them? im interested, regards