Search results for query: *

Fixed the wiring issue! When the car was tuned the mechanic by-passed the Ballast and used a poor connector. Took it apart, used some shrink tubing and encased it in a plastic tube. The only thing I have to figure out is how to fix the temperature gauge as it was working. Will be doing some...

I'm runnining an electronic MSD distributor so the ballast is disconnected I think 4spddragtop might be correct on the ignition switch itself. There is a lot of play in the ignition once the key is in. I will try giggling it around see if that is the problem and continue with other wires. As...

Cruising in the 67' Barracuda...pulled into my buddies driveway and died? Would only keep running if I had the key engaged for awhile, which is not good for the starter. Waited for a couple of minutes and would started right away and drive. Ignition relay switch? Thanks in advance.

Thanks again!!

Any other parts required then the 3 listed? The kit attaches to the transmission as the original cables?

Hi Brian, are these the parts required?: 1) Lokar Hi-Tech kickdown kit(KD-2904HT60) 2) Lokar Throttle Cable Bracket(SRK-4000) 3) Edelbrock 1481 - Carb Linkage Adapter(EDL-1481) http://www.summitracing.com/int/parts/lok-kd-2904ht60/overview/...

Converted from a 2 barrel to a 4 barrel setup with an Edelbrock performer 1406 series carb and intake manifold. What I have read is to get the throttle bracket(Mancinni Racing) and Trans Kick Down Cable Kit(Lokar). Is this the way to go???

My 273 car is at the garage but is that where the ground wire from the battery is?