Search results for query: *

have been looking around, I see that there are 4 grove big block lower crank pulley's out there , a lot on E-Bay, some are stepped, 2 groves are a smaller dia. then the other 2 groves. also Mancini has a new Billet Aluminum 4 grove for 108.00 cvf scrl 4cr hf is their part number. The 4 grove...

Hi thank you for your input on the Classic Air unit, what did you do to power up the unit ? since there is no extra fuses to pick up the power for the A/C

Some back ground 69 notchback Cuda, have 318 auto with center console, I have installed under dash Knee Knocker A/C unit have not charged the system, on the fence if I want to use it, had a friend of mine along for a ride , he had no leg room with seat all the way back, looked at Classic Air...

i may try again, i just checked the coolant level in the rad. and it is full, i would have thought since it came out of the overflow bottle, it would be on the low side, i just did not remember adding coolant since last year when i drove the car and did not have this issue ? i really do not want...

Thank you Dana67Dart, i read the report/testing from the link, i am having 2nd thoughts about this Evans coolant now, 1- it has a higher cylinder heads temp. 2,- aluminum parts questions, 3 - the coolant has high viscosity, while going through radiator by 20-25% which is hard on the water pump...

I to am using Evans Coolant, new build engine, so no old coolant in the whole new system, used Evans from the get go,have a slightly built 318, have a 22" Champion 3 core alum. radiator, stock 5 blade none clutch Mopar fan blade, with shroud , have a 180 degree thermostat, running a 16 lb cab on...

Hi Mopar Mike, I think that would work how much would you like ? how for shipping to Northampton pa 18067, do you take pay pal ?? Dave M.

that is the measurements of the one I have , I guess I need the 6-1/4 by 3 inches deep if a 2 groove ??

ok , measured , looks like 6-1/4 wide by 2 inches deep !

ok I took another look at my belts does any one have a 2 groove fan blade pulley for sale?

Installed a Sanden a/c compressor, have a 1970 318 v8, with power steering ,and lower pulley has 3 grooves, have belts installed but only make contact with the fan pulley for a small contact area so the fan is slipping and engine over heating does any one have a photo of how they have there...

Hi, Sorry I have a 69 cuda, I think I can see what I need to see from your photo. thanks dave

Hi, can/does anyone out there have a good photo of the area on the fire wall where the a/c hoses go thu for A NON-FACTORY A/C car , I am installing an under dash knee-knocker a/c unit and need to drill the holes for the a/c hoses to go thu the fire wall, I want to make sure I clear the dist. I...

thanks for all of the information

thanks for all of the information

Hi , looking for a good set of the tubes that go from the heater box up to the defrost vents in the dash of 69 cuda.

Hi , i bought a scs frigette under dash a/c unit from another memeber on here, i am in need of the wiring diagram to hook up the compressor wireing and the under dash unit. Does any one have that information???