Search results for query: *

Quick update.....I installed a deep transmission pan (+2 qts) and an extended fluid pickup and it shifts great on every pull. Lesson learned.

I was reading on the Hoosier web site, that you should inflate the tire not to exceed 40 lbs to seat the tire to the rims, then adjust the air pressure as needed. I inflated mine to 40# and let them sit for almost a week. I took it to the track last night and let the air out to 18# they did...

Went back to the track last night, with good results. After the first full pull that resulted in the trans NOT shifting into second, I went back to the pit and checked the trans fluid. It measured a little low on fluid. I added about 1/2 qt or Type F and took it back out. It ran good with...

I am manually shifting, and it was built by a place called Shifters in Jacksonville Florida. I will pull the dipstick this morning.

On a new set of Hoosier slicks with 16 PSI in each. I stuck a piece of tape on the tires aligned with the valve stems so I could tell if the wheel was turning in the tire. To my surprise, one side had turned about a quarter turn and the other side about a half turn. Is this normal? How much...

First run at the track was a normal run. Then, with a normal launch, when I shifted to second, it did not change. I got out of it and shifted again and it went to 3rd. Three runs with the same results. I have a B&M ratchet shifter and a Turbo action Cheeta XtremeAction manual valve body. Just...

Thanks for the information and pictures. Here is what I ended up doing. Not as nice as some of your, but it will do for now.

Fishmen67- do you have any pictures? Did you run the cables under the car andbehind the bumper?

I will take a look at the tail light tomorrow. I have a rotary switch now but I may have to get a push-pull link rod$

I have a 68 Barracuda that I am building for a mild bracket drag car. I am looking for a decent place to mount the require kill switch. I thought about running the wires through the sheet metal between the trunk lid and bumper, and building a bracket to mount on the bumper but that would be a...