Search results for query: *

If you look at a magnum VC gasket it is wider in the rear than it is in the front. So the extra 1/2 inch in the rear was resting on top of the head stud nut. And this caused the gasket to not sit flat when tighten down. The picture is just for reference of the VC's I am using.

Well I couldn't stand not knowing why it was leaking. So I went out to the garage took off Pass side VC and immediately I see the problem. We used ARP studs not bolts so when placing the VC and gasket on the head the rear stud nut is slightly higher than the bolt head would be and was holding...

Yea this was the last place I thought I would have a leak. But I'll take it apart this weekend and see what's going on.

13 inch/lbs and I have not checked the covers yet. Doing that this weekend. I was just wondering when looking at the gasket one end is wider than the other. So are these actually directional.

I can't seem to get my fabricated VC's to seal. Using the rubber gaskets with the metal inside. What is everyone using and had the best luck with?