Search results for query: *

I used the Auto Zone ball joint press (substituted for the thread-all or 6.5" bolt) with the sockets. Looks like a big C clamp. Worked okay, free rental but had to put down $120 for deposit. Good motivation to get job done. Moog bushings through NAPA - three of four bushings were okay, but...

Cutting the boot on the lower ball joint worked with the pickle fork. Used Dorman tie rod dust boots #13567 <$6, seem to fit large ball joint.

Outer races not fully seated spindle worn on bottom- outer bearing's inner race (use center punch to kneel enough to snug up inner race on spindle) Tighten nut and back-off till the washer just moves with screw driver