Search results for query: *

So, each coupon is not individually numbered so that it can only be used one time? I’m asking because I’m heading there today to buy a cart motor for my boy.

It says “original coupon must be presented “ how can anyone use your coupon???

My Bendack has been flawless 8 yrs

The best advice I can give is... take the oil and filter out of the car before you lift it up there. ask me how I know

I have to go to my neighbors garage to do alignment and exhaust work. Other than that, I think I like my 2 post.

Post heat is just as important. Cast should be around 400f preheat, then cool in vermiculite, sand or wrap it in ceramic blanket. If you have a buddy that can be ready with a torch as soon as you get done welding would be "grate" pun intended. That thin piece will lose heat quickly and start to...

Don't forget Sunnen

Well done. It's an inspiration!

I made one about 5 years ago....no luck yet, but someday its gonna work like a charm lifting them up in there!

If you need anything for it, Goodson and Regis are two good companies

I would want to know whose making those for Eastwood. (ask Them) As previously stated, make sure its not a fly by night company and in 4 yrs you can't find parts. Also i would'nt be bragging my welder weighs " half as much as similar welders". Lincoln and Miller have bean counters on the payroll...

Dad taught me to weld with a Lincoln sp-100 setup with the argon/co mix. That was 21 years ago and it still welds great and often. It has not been babied, and has seen a lot of hours. Anything over 3/16 I'll preheat for Max penetration. I would say even with preheating and champhering...