Search results for query: *

@azaustin, I just sent you a private message in regards to the pricing and parts numbers. For various styles of the push in nylon straps with the two pins, in most situations, they were used in areas in which the inner fender is recessed for clearance purposes and to stiffen the panel.

@azaustin, I have attached a picture of the two different styles of the under hood straps that we manufacture. There is actually two more as used on the C and E and 71 to 74 B-Body applications, but they are black nylon, so I did not picture them. The "flat" style has been documented as for...

We make the nylon straps and either offer them individually or in a kit. Looking at the picture that @azaustin posted, is the one question flat or does it have a slight hump in the middle of the strap? I can post a picture of the two styles tomorrow.

@macman340 , are you positive that your convertible had a seat divider? Due to the fact that the top has to collapse into the "well" between the back seat and the trunk compartment, no seat divider was used for the cars that I am most familiar with.

All of those rear window gaskets are a Steele product and will run around $210 plus the insert. The network of vendors selling the Steele product line is quite small and there is nobody else producing this gasket, so no competition for lower pricing. Personally, I would rather replace the...

Glad to see that things worked out well. I believe that most guys will tell you that having someone knowledgeable on the installation of a headliner is worth the money spent avoiding the frustrations. Going to be a sharp car!!

Thanks for sharing the information @RustyRatRod, we are a forum sponsor, but have not officially linked my profile to this site. Over on FBBO, my ID is @69bfan and it shows the sponsorship level. Either way, we are involved in the manufacturing, the wholesale and retail side of over 600 unique...

I have very limited knowledge of the early A-Body applications, but from looking at the pictures posted above, the seal that @early A Bob posted has the molded end to match up to the picture that @Moparman1967 pictured. If you look closely at a original profile or the reproduction profile, you...

Much of the OE style fasteners come from AMK Fasteners out of Winchester, VA. This is where many of the vendors purchase the hardware and then rebag or make up kits.

You can check around with your favorite vendor, but the door windlace is supplied to all of the vendors by the same source, Restoration Specialties. For a windshield gasket you can use either a Precision Gasket or Steele Rubber. The rear gasket to my knowledge is a Steele piece. For window...

Stephan, There is not a lots that is going to be available for the car. The windshield gasket, door seals (which color), window felts are available. The vent window seals, quarter glass and rear roll up window glass are not available to my knowledge. I will send you a private message as well...

Thanks for the information. Actually, M&H is a supplier as is Antique Auto Battery for reproduction battery cables. There were two different OEM vendors for the original cables and M&H was not one of them. M&H manufactures a quality product, but like I said earlier, unless you are working...

We are looking to add the 63 to 66 positive and negative battery cables to our current product listing of OEM correct battery cables. We have sourced samples of the 62 to 65 B-Body cables and are currently working on sourcing the A-Body cables. A gentleman has provided us the positive battery...